Thermador T36BT820NS Use and Care Manual - Page 20
en-us, Ice maker - parts
View all Thermador T36BT820NS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
en-us Ice maker Fault Possible cause Remedial action The ice maker doesn't work. Ice maker is not connected to the mains supply. Call customer service. Ice maker does not contain any fresh Ensure that the water is properly connected. water. The freezer compartment temperature Check freezer compartment temperature is too warm. and, if required, set slightly colder. The ice maker does not make enough ice or the ice is deformed. The appliance or ice maker has only just been switched on. A lot of ice has been taken. Approx. 24 hours is needed until ice production starts. Approx. 24 hours is needed until the ice cube container is filled again. Low water pressure. Connect the appliance to the stipulated water pressure only (see chapter Connecting appliance, section Water connection). The water filter is bunged up or used. Change the water filter. The ice maker does not make The ice maker is switched off. any ice. Switch the ice maker on at the control panel. The appliance is not supplied with water. Contact the installer or the water supply company. Water supply has kinks. Turn off the water supply at the shut-off tap. Smoothen out the kinks, exchange where necessary. Low water pressure. Connect the appliance to the stipulated water pressure only (see chapter Connecting appliance, section Water connection). Temperature in the freezer space is Set temperature slightly colder in the freezer too warm. compartment. Ice cube container is not properly inserted. Check the position, re-insert where necessary. Incorrect shut-off tap installed. Incorrect taps can cause low water pressure and damage to the appliance. Ice forms in the inflow hose to the ice maker. Low water pressure. Connect the appliance to the stipulated water pressure only (see chapter Connecting appliance, section Water connection). Shut off tap incorrectly opened. Open shut off tap fully. Temperature in the freezer space is Set temperature slightly colder in the freezer too warm. compartment. Water runs from the appliance. The water connection hose is not properly sealed. Replace the hose with a manufacturer's original part. Incorrect shut-off tap installed. Incorrect taps can cause low water pressure and damage to the appliance. The water pressure is less than Low water pressure. usual. Connect the appliance to the stipulated water pressure only (see chapter Connecting appliance, section Water connection). Shut off tap incorrectly opened. Open shut off tap fully and check for leaks. Check the minimum through flow. Incorrect shut-off tap installed. Incorrect taps can cause low water pressure and damage to the appliance. Water supply has kinks. Turn off the water supply at the shut-off tap. Smoothen out the kinks, exchange where necessary. The water filter is bunged up or used. Change the water filter. 20
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67