Thermador UCVM30FS Installation Instructions - Page 3

ṇ SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. READ AND SAVE THESE INSTRUCTIONS ṇ WARNING To reduced the risk of fire, electric shock, or injury to persons, observe the following: A. Installation work and electrical wiring must be done by authorized person(s) in accordance with all applicable codes and standards, including firerelated construction. B. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fired Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. D. Ducted fans must always be vented to the outdoors. E. Always unplug or disconnect the appliance from the power supply before servicing. F. This unit is designed for indoor use only. Use this unit only in the manner intended by the manufacturer. G. Make certain the cooktop is appropriate for use with a downdraft vent. H. Not intended for use with professional-style cooktops. ṇ WARNING For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages. To reduced the risk of fire, use only metal duct work. To reduce the risk of fire, electric shock and injury to persons, Downdraft must be used with Internal, Remote or Inline Blower. To reduce the risk of fire or electric shock, do not use the fan with any solidstate speed control device. This appliance has been found to be in compliance with UL 507 Standard for Electric Fans and CAN/CSA-22.2 No. 113 Canadian Standard for Fans and Ventilators. It is the responsibility of the owner and the installer to determine if additional requirements or standard apply in specific installation. 3