Thermador UCVM30XS Instructions for Use - Page 10

To Clean By Hand, To Clean Intake Housing, Charcoal Filter Replacement, Cleaning Agents

Page 10 highlights

In the dishwasher Note: Slight discoloration is possible when cleaning the grease filters in the dishwasher. This is normal and does not affect the performance of the grease filters. • Do not clean extremely dirty grease filters with dishes. • Loosely position the grease filters in the top rack of the dishwasher. Wash the filters through on Normal cycle. The grease filters must not be jammed in. Replace filters and front panel before using downdraft. Make sure that the filters are seated properly. To replace the front panel, align the brackets at the bottom and pivot the panel inwards until it sits in place or the TABS are engaged. CAUTION Failure to engage tabs properly may cause chimney to jam and fail to raise up. To Clean By Hand Note: You can use a degreaser if soiling is stubborn. The THERMADOR Stainless Steel Conditioner can be purchased online (US only) at: www.thermador-eshop.com. NOTICE: The use of brand names is intended only to indicate a type of cleaner. This does not constitute an endorsement. The omission of any brand name cleaner does not imply its adequacy or inadequacy. Many products are regional in distribution and can be found in the local markets. It is imperative that all products be used in strict accordance with instructions on the package. • Soak the grease filters in warm soapy water for 10-15 minutes using a mild detergent. • Use a brush for cleaning and then rinse the filters well. • Allow the grease filters to drip dry completely before placing them back into the downdraft. Clean and dry intake housing, then reinstall or replace filters before using downdraft. To Clean Intake Housing • Pull front panel up and out. • Remove both filters. • Use a mild detergent. DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING POWDERS. Clean and reinstall or replace both filters and install front panel before using downdraft. NOTICE: The use of brand names is intended only to indicate a type of cleaner. This does not constitute an endorsement. The omission of any brand name cleaner does not imply its adequacy or inadequacy. Many products are regional in distribution and can be found in the local markets. It is imperative that all products be used in strict accordance with instructions on the package. NOTE: Do not use cooktop while hood is disassembled. Charcoal Filter Replacement It is recommended that you replace the recirculation filter every 6 months. However, this may vary, depending upon the type and amount of cooking you do. To change the charcoal filter, remove the decorative cover plate (on toe kick or base of the cabinet) and replace the charcoal filter by a new one, part number UCVFILTER. Reinstall the decorative cover plate. Cleaning Agents To prevent various surfaces from becoming damaged due to incorrect cleaning agents, follow the specifications given in the table. Do not use: • cleaning agents that are harsh or scouring, • cleaning agents with high alcohol content, • hard scouring pads or sponges, • high-pressure cleaners or steam cleaners. Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks. After cleaning, place all parts in their proper positions before using. Thoroughly rinse all new sponges before use. Observe all instructions and warnings accompanying cleaning agents. Area Stainless steel Varnished surfaces Aluminum and plastic Glass Controls Cleaning agents Warm soapy water: Clean with a dish rag and dry with a soft towel. Only clean stainless steel with the grain. Specific products for stainless steel care are available from customer service or from specialized retailers. Apply a thin layer of the care product with a soft cloth. Warm soapy water: Clean with a damp dish rag and dry with a soft towel. Do not use stainless steel cleaner. Glass cleaner: Clean with a soft cloth. Glass cleaner: Clean with a soft cloth. Do not use a glass scraper. Warm soapy water: Clean with a damp dish rag and dry with a soft towel. Risk of damage to electronics due to moisture penetration. Never clean controls with a wet cloth. Do not use stainless steel cleaner. Page 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

Page 10
In the dishwasher
Note:
Slight discoloration is possible when cleaning the grease filters in
the dishwasher. This is normal and does not affect the performance of
the grease filters.
Do not clean extremely dirty grease filters with dishes.
Loosely position the grease filters in the top rack of the dishwasher.
Wash the filters through on Normal cycle. The grease filters must not
be jammed in.
Replace filters and front panel before using downdraft. Make sure that
the filters are seated properly.
To replace the front panel, align the brackets at the bottom and pivot the
panel inwards until it sits in place or the TABS are engaged.
CAUTION
Failure to engage tabs properly may cause chimney to jam and
fail to raise up.
To Clean By Hand
Note:
You can use a degreaser if soiling is stubborn. The THERMADOR
Stainless Steel Conditioner can be purchased online (US only)
at: www.thermador-eshop.com.
NOTICE:
The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The omission of
any brand name cleaner does not imply its adequacy or inadequacy.
Many products are regional in distribution and can be found in the local
markets. It is imperative that all products be used in strict accordance
with instructions on the package.
Soak the grease filters in warm soapy water for 10-15 minutes using a
mild detergent.
Use a brush for cleaning and then rinse the filters well.
Allow the grease filters to drip dry completely before placing them
back into the downdraft.
Clean and dry intake housing, then reinstall or replace filters before using
downdraft.
To Clean Intake Housing
Pull front panel up and out.
Remove both filters.
Use a mild detergent. DO NOT USE ABRASIVE CLOTH, STEEL
WOOL PADS, OR SCOURING POWDERS.
Clean and reinstall or replace both filters and install front panel before
using downdraft.
NOTICE:
The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The omission of
any brand name cleaner does not imply its adequacy or inadequacy.
Many products are regional in distribution and can be found in the local
markets. It is imperative that all products be used in strict accordance
with instructions on the package.
NOTE:
Do not use cooktop while hood is disassembled.
Charcoal Filter Replacement
It is recommended that you replace the recirculation filter every
6 months. However, this may vary, depending upon the type and amount
of cooking you do.
To change the charcoal filter, remove the decorative cover plate (on toe
kick or base of the cabinet) and replace the charcoal filter by a new one,
part number UCVFILTER. Reinstall the decorative cover plate.
Cleaning Agents
To prevent various surfaces from becoming damaged due to incorrect
cleaning agents, follow the specifications given in the table. Do not use:
cleaning agents that are harsh or scouring,
cleaning agents with high alcohol content,
hard scouring pads or sponges,
high-pressure cleaners or steam cleaners.
Rub stainless steel finishes in the direction of the grain. Wipe area dry to
avoid water marks.
After cleaning, place all parts in their proper positions before using.
Thoroughly rinse all new sponges before use.
Observe all instructions and warnings accompanying cleaning agents.
Area
Cleaning agents
Stainless steel
Warm soapy water:
Clean with a dish rag and dry with a soft towel.
Only clean stainless steel with the grain.
Specific products for stainless steel care
are available from customer service or from
specialized retailers. Apply a thin layer of the
care product with a soft cloth.
Varnished surfaces
Warm soapy water:
Clean with a damp dish rag and dry with a soft
towel.
Do not use stainless steel cleaner.
Aluminum and
plastic
Glass cleaner:
Clean with a soft cloth.
Glass
Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Controls
Warm soapy water:
Clean with a damp dish rag and dry with a soft
towel.
Risk of damage to electronics due to moisture
penetration. Never clean controls with a wet
cloth.
Do not use stainless steel cleaner.