Thermador WDC30E Installation Instructions - Page 6
Installation, procedure
![]() |
View all Thermador WDC30E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation procedure Prepare cabinet cutout Install antiĆtip assembly 4 Prepare cabinet cutout according figure 3 and install electrical connection. Slide uĆshaped plastic part of antiĆtip assembly onto middle of channel at rear of warming drawer as shown in figure 4. Position bracket of antiĆtip assembly on floor of cabinet opening as shown in Figure 4 and attach with two torx head screws. Connect to electricity Install warming drawer Insert plug into threeĆprong, grounded outlet. See Power requirements" for electrical specifications. Slide warming drawer assembly into cutout until it is flush with cabinet. Note: Ensure that the connector lead doesn' t become trapped or bent. Verify that antiĆtip assembly is properly installed by pulling down on the front of the drawer. The bracket should hold the drawer in place. Align the appliance flush with the units and secure it to cabinet through four screw holes in front frame (drill pilot holes in cabinet first if necessary). Use torx head screws included. 6
![](/manual_guide/products/thermador-wdc30e-installation-instructions-b826eb0/6.png)