Tineco PURE ONE S15 Essentials Instruction Manual - Page 13

EN Runtime • When in AUTO mode, the runtime is approximately 40 minutes. When MAX power is used, the runtime is approximately 10 minutes. • Estimated runtime data was obtained by a Tineco Laboratory using one battery and nonmotorized accessories. Charging Time • A full charge takes approximately 5.5 hours. • Estimated data was obtained by a Tineco Laboratory using ambient temperatures between 39.2°F (4°C) to 104°F (40°C). Indicator For any of the following notifications, consult the "Troubleshooting" section of this manual. When in Use Blinking: motor failure. During Charging Charging (Battery 0-99%) Battery icon: solid green. Battery indicator: blinking green. Tineco indicator: blinking. Fully charged (Battery 100%) In 5 mins Battery icon & Battery indicator: solid green. Tineco indicator: illuminated. After 5 minutes: all indicator lights turn off. Battery level > 20%: solid green light. Battery icon blinking green: No battery pack or battery pack installed incorrectly. Battery level ≤ 20%: solid red light. Both blinking red: fault. Blinking red light: fault. MAINTENANCE Blinking: brush roller has a blockage. Blinking: appliance has a blockage, either in the filter or the dustbin. Note: • Clean the dustbin and filters after each use. • To maintain high performance, wash and dry the pre-filter monthly, replacing it every 6 months. Wash and dry the HEPA filter every 3 months, replacing it every 12 months. Dustbin, Mesh Filter and Blinking: sensor inside the dustbin is obstructed, or the dustbin is not correctly installed. Pre-filter 1.Turn counter-clockwise to remove the filters. Fig.E-1 2.Do not turn the appliance upside down when removing or installing the filter to prevent dust from entering the motor. Fig.E-2 11