Toro 51346 Operation Manual - Page 3

3 Setup Adjusting and Assembling the Trimmer 1. Loosen the knob (A), then move the assist handle up or down the shaft to your desired height. 2. Pivot the assist handle to a comfortable position (B), then tighten the knob. A 3. Install the guard as shown, snapping it into both sides of the trimmer. B m-7852 m-6314/6326 Operation Warning During operation, the trimmer may throw objects in the operator's or a bystander's direction, causing injury. S Wear safety goggles or other suitable eye protection, long pants, and shoes while operating the trimmer. S Keep bystanders away from the work area. Warning When the trimmer is running the cutting head is spinning. If you contact the cutting line or cutting head, you could be injured. S Keep the cutting head away from your hands, feet, and bystanders. Keep the guard in place and in working order. S Wear shoes and long pants when using the trimmer. S Ensure that the cutting head has stopped and you disconnect the trimmer from the power source before you service or examine the cutting head. Do not start the trimmer unless your hands are on both handles and the cutting head is down near the ground. S Do not allow the trimmer to cut into the cord. Caution The blade under the guard is sharp and can cut you. Be careful when handling the trimmer so that you do not accidentally cut yourself. 4. Install the metal wire guide. A. B. Connecting to a Power Source Warning If you do not fully seat the extension cord on the inlet plug, the loose plug could lead to overheating and cause a fire, possibly burning you or others. Ensure that you fully seat the cord on the plug and use the cord lock feature to secure the cord. m-6319 m-6327 Important: Do not use a damaged cord. 3352-878 m-6317