Toshiba 23HL84 User Manual - Page 17

Introduction Connecting your TV Setting up your TV Setting up your TV Using the remote control Preparing the remote control for use With the remote control, you can operate your TV, most cable TV converters/satellite receivers, VCR and DVD player models together, even if they are different brands. If you will be using your TV with a Toshiba satellite receiver, VCR or DVD player, your remote control is already programmed and ready to use. If you own different brands of cable TV converters/satellite receivers, VCRs and/or DVD players, you first have to program your remote control. (See "Programming the remote control for use with a cable TV converter/satellite receiver, VCR or DVD player" on page 18.) Installing the remote control batteries To install the batteries: 1. Open the battery cover on the back of the remote control. 2. Install two "AA" size batteries. Match the + and - signs on the batteries to the signs on the battery compartment. Note: The TV remote control may or may not operate your cable TV converter/satellite receiver, VCR or DVD player. Refer to your owner's manuals supplied with the equipment to see which features are available. In addition, the original controllers may have features not available on this remote control. If you would like to continue to use these features, you may want to use the original remote control. Caution: Never throw batteries into fire. Note: • Always dispose of batteries in a designated disposal location. • Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations. • Never mix battery types or use new and used batteries in combination. • When necessary to replace batteries in the remote control, always replace both batteries with new ones. • Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment. 3.Close the battery cover on the remote control until the lock snaps. Using the remote control with a cable TV converter/satellite receiver, VCR or DVD player To control a cable TV converter/satellite receiver: Input (TV) Power Program the remote control to recognize the brand of your cable TV converter/satellite receiver (see "Programming the remote control Channel Numbers CH Enter Pic Size (TV) for use with a cable TV converter/satellite TV • CBL/SAT• receiver, VCR or DVD VCR • DVD player" on page 18.) The selector buttons shown at right will control the cable TV Channel vw Volume vw (TV) converter/satellite Mute (TV) receiver. TV/VCR Set the TV • CBL/ SAT • VCR • DVD selector to "CBL/SAT" Light first. To control a VCR: Program the remote control to recognize Input (TV) Power the brand of your VCR (see "Programming the remote control for use Channel Numbers with a cable TV converter/satellite receiver, VCR or DVD CH Enter Pic Size (TV) player" on page 18.) The buttons shown at Volume vw (TV) right will then control TV • CBL/SAT the VCR. • VCR • DVD Set the TV • CBL/ selector SAT • VCR/DVD Channel vw selector to "VCR" first. Mute (TV) VCR controls Light 17 Using the TV's Features Appendix J3R50121A(E)P17-24 17 12/08/2004, 10:50 AM