Toshiba 46RV525RZ Owners Manual - Page 37

To tune to a channel or input in Select mode: 1 While watching TV, press ~ jg;) .... or ~ C§J ~ to open the Channel Browser™ and surf back to a previous item or forward to the next item in the list. ]n Select mode, when you stop on an item in the Channel BrowserHt, it will be highlighted but you 8 must press to tune the TV to the highlighted item. 2 8 Press to tune the TV to the highlighted item. 3 Press ~IT 0 to close the Channel Browser.l.M . Adding and clearing channels and inputs in the History List Adding channels and inputs to the History List: As a channel or input is tuned, the Channel Browser™ adds it to the History List and displays it on the "right side" of the Channel Browser™. Previously tuned channels/inputs are "shifted" to the left, eventually BACK moving otf the left side. Press jg;) .... to surf backward through the previously tuned channels/inputs. Any channel or input that is tuned repeatedly will not be repeated in the History List, but instead is moved to the end of the list on the right side of the Channel Browser™. The Channel BrowserTl\! will store the following channels: • All channels that are tuned using the numeric buttons on the remote control. • All channels that are tuned usi ng r£) or ~ on the remote control. Note: Whenever an item is selected that cannot be tuned (for various reasons), the TV will automatically tune to the previously viewed channel or input. Clearing channels from the History List: • Reconfiguring the ANT/CABLE input will clear the History List. Note: See page 29 for details on configuring the antenna input. • Once 32 channels or inputs are stored in the History List, the oldest item will be removed from the list when a new channel or input is tuned. • Turning off the TV will clear the History List. Setting the Channel Tuning Mode This feature allows you to choose how tuning will be handled for analog and digital channels when the TV is in Antenna mode. Note: To use this feature, the Input Configuration must be set to Antenna (1& page 29). The channel tuning mode has three options. , . Mode' " .', Description Both analog and digital channels can Standard be tuned normally Auto (default) Digital channels will have priority when manually entering a channel number using the Channel Number (0-9) on the remote control, analo?c~~annelscan ® , still be tuned by r£) / if available Digital Only digital channels can be tuned Note: Digital mode will be most useful after analog channels are shut down by the government in 2009. To set the Channel Tuning Mode: 1 From the Setup menu, highlight Installation and 8. press A new set of Installation menu icons will appear. 2 Open the Terrestrial menu, highlight Channel Tuning Mode, and then press ~ and . . . . to select your desired mode. Note: • The Channel Add/Delete & Channels Block windows as well as the Channel Browser ANT/ CABLE list will be updated automatically when you change the mode. Also, the History List will be cleared, but the Favorites List will be saved. • Even if the Channel Tuning Mode is set to Digital, analog channel 3 will still be the default channel to prevent the initial case where no digital channels have been found in prior channel scans. (Channel Add/Delete will not have anything listed until a scan is done.) 37 I