Toshiba 56HM66 Installation Guide - English - Page 9

DLP_Inst.book Page 9 Wednesday, February 22, 2006 6:18 PM Connecting your TV Connecting a VCR and antenna or Cable TV (no Cable box) You will need: • signal splitter • coaxial cables • standard A/V cables - For better picture performance, if your VCR has S-video, use an S-video cable (plus the audio cables) instead of the standard video cable. Do not connect both types of video cable to VIDEO 1 at the same time or the picture performance will be unacceptable. - If you have a mono VCR, connect L/MONO on the TV to your VCR's audio out terminal using the white audio cable only. Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT 2, VIDEO 1, and VIDEO 2 terminals when the applicable input mode is selected.* From Cable TV or antenna Signal splitter IN OUT OUT To use the TV Guide On Screen™ recording features (if applicable to your TV model): 1 Connect the G-LINK™ cable according to the instructions (- page 17). 2 Make sure the VCR is connected to the VIDEO/ AUDIO OUT terminals on the TV (see illustration). 3 Set the VCR to the appropriate line input (refer to your VCR owner's manual for details), and then turn OFF the VCR. 4 See the TV Guide On Screen™ Interactive Program Guide for details on setting up and using the TV Guide On Screen™ system. The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs, and other materials is prohibited under the Copyright Laws of the United States and other countries, and may subject you to civil and criminal liability. In the United States, TV GUIDE and other related marks are registered marks of Gemstar-TV Guide International, Inc. and/or one of its affiliates. In Canada, TV GUIDE is a registered mark of Transcontinental Inc., and is used under license by Gemstar-TV Guide International, Inc. Stereo VCR VIDEO IN from ANT CH 3 CH 4 OUT to TV AUDIO L R IN IN OUT L R TV To view the antenna or Cable signal: Select the ANT 1 video input source on the TV.* To view the VCR: Turn ON the VCR. Select the VIDEO 1 video input source on the TV.* * To select the video input source, press INPUT on the remote control (- Operating Guide). To program the TV remote control to operate other devices, see the Operating Guide, Chapter 2. 9 DLP Inst (E/F) Web 213:276