Toshiba 56HMX96 Owner's Manual - English - Page 53

HMX96_EN.book Page 53 Friday, April 28, 2006 12:03 PM Chapter 5: Using the TV's features • Clock Phase: Helps to reduce noise and sharpen the picture. The adjustment range is within ±2 from center.* • Sampling Clock: Helps to redure noise and minimize periodic vertical stripes on the screen. The adjustment range is within ±15 from center.* * The range of adjustment may vary slightly. Understanding the auto power off feature The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This feature functions in ANT 1 and ANT 2 modes only. Displaying TV setting information on-screen using RECALL Understanding the last mode memory feature To display TV setting information on-screen: Press E on the remote control. The following information will display on-screen (if applicable): • Current input (ANT 1, ANT 2, VIDEO 1, etc.) • If ANT 1 or ANT 2 is the current input, either "CABLE" (for cable TV) or "TV" (for over-the-air broadcasts). • Channel number (if in ANT 1 or ANT 2 mode) • Digital signal strength indicator (bar graph in lower right corner of screen; for ATSC signal only) Note: The signal strength indicator will react to fading and increasing signals. • Remaining time on sleep timer (if set) • Stereo or SAP audio status • V-Chip rating status • Picture size • Video resolution • Lamp mode (appears only if the TV is in High Bright mode) STEREO NC-17 Sleep Timer: 18 min. If the power is cut off while you are viewing the TV, the Last Mode Memory feature automatically turns on the TV when the power is resupplied. Note: You should unplug the TV's power cord if it is possible that you will be away from the TV for an extended period of time after the power is restored. Lamp High Bright Natural 480i ANT 1 CABLE 81-1 Sample RECALL screen To close the RECALL screen: Press E again. 53 HMX96 (E/F) Web 213:276