Toshiba BDX2250KU Owners Manual - Page 26

Customizing the Function Settings Network Connection Setting 1. Press / to select Network in stop mode, then press button, I. If no Ethernet cable is connected to the ETHERNET jack on the back of your player, a screen similar to the following appears: Wireless Network List WiFi Protected Setup (WPS) Manual IP Settings For detailed operations, refer to the "Configuring a wireless Internet connection". II. If a wired connection is made to your player, a screen similar to the following appears: Wired IP Settings Link Status Link up MAC Address 00:23:18:75:b1:2b IP Mode Dynamic IP Address 128.60.3.31 Subnet Mask 255.255.0.0 Gateway 128.60.1.1 Primary DNS 128.60.1.41 Secondary DNS 128.60.1.42 Apply Cancel Network Test Refer to the "Configuring a wired Internet connection" for details. Note: "Wireless" and "Wired" are optional and do not appear at the same time. Normally, "Wireless" is shown without wired connection. While using a wired Internet connection, "Wireless" is disabled and "Wired" is activated. Configuring a wired Internet connection 1. Press / to select Network in stop mode, then press button to enter the following screen: If the network connection is active, Link Up appears next to Link Status. If the network connection is not active, Link Down displays next to Link Status. 2. Press / to select IP Mode, then press OK. 3. Press / to select an IP mode. You can select: • Manual - Lets you manually configure network settings, such as IP address, subnet mask, and gateway settings. • Dynamic - Uses DHCP to automatically obtain an IP address. 4. Press / / / to highlight Network Test, and press OK to test your network connection. 5. Press or RETURN to go to the previous menu. Configuring a wireless Internet connection This section describes how to configure the Blu-ray Disc™ player for accessing the internet via a WiFi connection.The procedure for connecting to a wireless network depends on various network parameters. Read the following configuration methods to determine which instructions to use to connect to your network. I. Connection to the wireless Network which you select a. Connecting to an Unencrypted Wireless Network b. Connecting to an Encrypted Wireless Network II. Connection to the wireless Network using Wi-Fi Protected Setup (WPS) a. Connecting to a Wireless Network Using WPS Pushbutton b. Connecting to a Wireless Network Using WPS PIN III.Connection to the wireless Network using Manual IP Configuration Description of the Wireless Network List Display Choosing "Network List" in the wireless network setup menu will cause a list of available WiFi networks to appear, as shown below: Network List WiFi a WiFi-me* WiFi b g n WiFi a WiFi b g WiFi b g Panda dlink_media NTGR 11g Airport_SN 26