Toshiba DVR670 Owner's Manual - English - Page 114

TROUBLESHOOTING Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. Symptom Remedy The power does not turn on. • Check that the AC power cord is connected securely. • Check the breaker (in case of power failure). • Press [TIMER SET] to cancel the timer standby mode. There is no picture. • Re-connect the connecting cords securely. • Check if the connecting cords are damaged. • Check the connection to your TV (pages 19-22). • Check if the progressive scan mode is set correctly according to your TV (page 106). • Switch the input selector on your TV (such as to "L1") so that the signal from the unit appears on the TV screen. TV program reception does not fill the • Try to set the channels with "Auto Channel Preset" or "Manual Channel TV screen. Preset" in "Channel" menu (pages 27-29). • Select a channel of any TV program using [CH / ]. TV channels cannot be changed. • Switch the input to TV. • Connect the RF coaxial cable correctly (pages 19-24). TV program pictures are distorted. • Check if all the connections are made correctly (pages 19-24). • Adjust TV antenna. • Adjust the picture. (Refer to the TV's instruction manual.) • Place the unit and TV farther apart. • Place the TV and any bunched RF coaxial cables farther apart. Playback picture is distorted. • Keep the device which may cause electrical disturbances, such as a cellular phone, away. Playback picture or TV program from • If the playback picture output from a DVD player, VCR or tuner goes the device connected through the unit through the unit before reaching your TV, the copy-protection signal is distorted. applied to some programs could affect picture quality. Disconnect the D playback device in question and connect it directly to your TV. V No analog TV closed captions are output. D • If you are using HDMI connection to watch the TV programs through this unit's tuner, analog TV closed caption cannot be output. Try using other connection. • There is no sound. V C R • Re-connect all connections securely. • Check if the connecting cord is damaged. • Check the connections to the amplifier input. • Check if the input device setting on the amplifier is correct. • When the unit is in pause mode or in slow-motion playback mode, sound is not output. This is not a malfunction. • When the unit is in fast forward or fast reverse mode, sound is not output. This is not a malfunction. • If the audio signal does not come through the DIGITAL AUDIO OUT (COAXIAL) jack, check the setting in "Audio Out" (page 101). • While the setup menu or timer programming display is shown, or while the screen saver is active, the audio is muted. No DTS sound on digital output. • Change the setting menu for "DTS" to "ON". No DTS sound from analog output • This unit has no analog sound output when playing back the selected DTS sound mode. Nothing was recorded even though you set the timer setting correctly. • There was a power failure during recording. • The unit's internal clock stopped due to a power failure that lasted for more than 30 seconds. Reset the clock (page 32). • The program contains copy protection signals that restricts copying. • The timer setting overlapped with another setting that has priority. Timer recording does not start. • No disc is inserted. • A disc is not recordable (finalized DVD-RW/-R, finalized DVD+R, a fully recorded disc, etc.). Timer recording is not complete or did • The timer setting overlapped with another setting that has priority not start from the beginning. (page 54). • Disc space was not enough. • "Make Recording Compatible" is not set to "ON", when recording onto DVD+RW/+R that was recorded on other unit. Timer recording is impossible. • Make sure appears on the front panel display of this unit. If not, press [TIMER SET]. 114 EN &4,6%@%73,6@&/@WJOEE