Toshiba SD-K530SU Owners Manual - Page 38
Controlling Your Cable Box/DSS, Satellite Receiver
View all Toshiba SD-K530SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Controlling Your Cable Box/DSS® Satellite Receiver Setting Cable Box/DSS® Satellite Receiver Control Codes 1. Press CABLE BOX to set the remote control operating your Cable box/DSS® Satellite Receiver. 2. While holding down PROGRAM button, enter the two digits of your Cable box/DSS® Satellite Receiver Brand Code (listed on page 39) using number buttons. 3. Release PROGRAM. Point the remote control at your Cable box/DSS® satellite Receiver and use each button listed below to make sure that your Cable box/DSS® satellite receiver is operated correctly. By pressing POWER CH/TRK +/- Number buttons ENTER You can Turn the Cable box/DSS® satellite receiver on or off. To select Cable box/DSS® satellite receiver channels in the upper or lower direction, (Not applicable to some brands of Cable box/DSS® satellite Receiver.) To select desired channels to record. To use for the Cable box's Enter Key. (Some cable boxes require you to use 100 button as the enter button.) Important Some Cable box/DSS® satellite receiver may not respond to all the operations above, or may not be operated at all with this remote control. In this case, operate them with its own remote control. Note For some brands, several control codes (brand codes) are allocated. Try each of them until the buttons work on your TV. If you replace the remote control's batteries, set the brand code again. CABLE BOX POWER PROGRAM Number buttons 100 CH/TRK ENTER 38