Toshiba SDP2000 User Manual - Page 75

Connections Using the Battery Pack Warning • Do not use a battery pack other than one specified as it can result in a fire or damage to the unit. • Do not heat, open, or short-circuit the battery pack. Do not throw the battery pack into a fire. Doing so may cause an explosion or a fire. • Attach the battery pack properly following the explanation below. Make sure that the battery pack is attached firmly to the player when using it. Otherwise, the battery pack may become detached and cause personal injury. Use a battery pack MEDB02SX (supplied) or MEDB02LX (not supplied). Charge it before using. Attaching the battery pack First disconnect the AC adapter and the power cord from the player, then attach the battery pack. 1 Turn the player off. 2 Turn the player upside down. 3 Open the connector cover on the rear of the player by pressing it. Open the connector cover 1 2 Charging the battery pack 1 Turn the player off. The battery pack will charge only when the POWER to the player is turned OFF. 2 Attach the battery pack to the player. 3 Connect the supplied AC adapter and the power cord to the player. 20 Charging starts, and the POWER/CHG indicator illuminates in orange. When the charging is completed, the POWER/CHG indicator turns off. Notes • The attached battery pack may get warm when you are charging it or operating the player. This is not a defect. • The POWER/CHG indicator flashes in green when the power in the battery pack is running low. • Charge the battery with a surrounding temperature of +10°C to +30°C. 4 Turn the battery pack over and matching it to the line 1 on the player. Simultaneously insert the hooks of the battery pack into the corresponding holes on the player. Then, slide the battery pack in the direction of the arrow 2 until a "click" is heard. Battery pack Charging time of a battery pack MEDB02SX (supplied) approximately 5.5 hours MEDB02LX (not supplied) approximately 7.5 hours The battery pack can be charged only when the DVD player is switched OFF. Charging time depends on environmental conditions. 2 1 1 2 Match to line 1 LCD brightness while using the battery pack Since the player operates in a power saving mode when the battery pack is attached, LCD brightness may be reduced. It can be restored by pressing the DIMMER button on the remote control. A brighter LCD display will shorten battery pack life. Note Remove the battery pack from the player after being used. Continuous playback time while using the battery pack MEDB02SX (supplied) up to approximately 3.5 hours MEDB02LX (not supplied) up to approximately 5.5 hours (Conditions: 25°C, output from the speakers, LCD brightness minimized, new battery pack in use.) • Continuous playback time may vary depending on battery pack status, operational status and environment conditions. • Low temperature will shorten the playback time. 75