Toshiba SDP2000 User Manual - Page 78

Others Before Calling Service Personnel Check the following guide for the possible cause of a problem before contacting service. Symptoms and correction Symptom No power. The player turned off by itself. No picture. Cause • The AC adapter or power plug is disconnected. • The battery pack has been removed. • Dead batteries. • The automatic power off function turned the unit off. • The connected TV is not set to receive DVD signal output. No sound. • The output signal is set to the External Screen mode. • The equipment connected via the audio/ video cable is not set to receive DVD signal output. • The volume is too low. • The audio receiver or TV is turned off. The playback picture has occasional distortion. • The setting of output sound format is incorrect. • The disc is dirty. • Player is in fast forward or fast reverse mode. • The main unit was moved or given a shock. Brightness is unstable or noises are present in the playback pictures. The player does not start playback. • The disc is not set firmly. • The effect of copy protection. • No disc is inserted. • An unplayable disc is inserted. • The disc is inserted upside down. • The disc is not inserted securely. Correction • Connect the AC adapter or power plug securely. • Install the battery pack. • Re-charge the battery. • Press the PLAY button. Page 20 - - 25 • Select the appropriate video input mode 22 on the TV so the picture from the player appears on the TV screen. • Set the output signal properly. 25 • Select the correct input mode of the audio receiver so you can listen to the sound from the player. 68 , 69 • Adjust the volume by turning the volume 24 control. • Turn on the equipment connected with the audio/video cable. 68 - 74 • Select the proper audio setting. 38, 56 59 • Eject the disc and clean it. 10 • Sometimes a small amount of picture - distortion may appear. This is not a malfunction. • Vibrating or shaking the unit during - playback may produce distortion. This is not a malfunction. If not restored to usual status, stop playback and start again. • Remove the disc and set it again. 22 • Connect the player directly to the TV. 68 Avoid connecting the player to a VCR or TV/VCR combination. • Insert a disc. 22 • Insert a playable disc. (Check the disc 12 type and color system.) • Insert the disc with the playback side 22 down. • Insert the disc securely in the disc holder. 22 • The disc is dirty. • Clean the disc. 10 • The parental lock function is set. • Cancel the parental lock function or 62 change the parental lock level. Playback does not follow the • It is in the repeat playback mode, memory • These operations may prevent a proper - course of the disc's program. playback, etc. progression of the contents. Buttons do not work. • Power supply fluctuations or other • Turn the power on or off with the - abnormalities such as static electricity may POWER button. Or disconnect the power interrupt correct operation. plug and insert it into the wall outlet again. The remote control does not • The remote control is not pointed at the • Point the remote control at the remote 19 work properly. remote sensor of the player. sensor of the player. • The remote control is too far from the player. • Operate the remote control within about 19 3 m. • The batteries in the remote control are • Replace the batteries with new ones. 19 exhausted. 78