Toshiba TDP-WX5400U Owners Manual - Page 5

IMPORTANT SAFETY INSTRUCTIONS (Continued) 20. If glass components, including lens and lamp, should break, contact your dealer for repair service. This product incorporates glass components, including a lens and a lamp. If such parts should break, please handle with care to avoid injury and contact your dealer for repair service. The broken pieces of glass may cause to injury. In the unlikely event of the lamp rupturing, thoroughly clean the area around the projector and discard any edible items placed in that area. 21. Servicing Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 23. Safety Check Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 24. Do not leave thermal-paper documents or easily deformed items on top of the unit or near the air exhaust for long periods of time. The heat from the unit could erase the information on the thermal paper, or cause deformation or warping. 25. Do not use the product in a closed installation state. Do not place the product in a box or in any other closed installation state. Otherwise it may overheat. This could result in a risk of fire. 22. Replacement Parts When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.  POWER SUPPLY INFORMATION If your line voltage is 220 to 240V, use one of the following types of cable/plug. Plug configuration Plug type Plug Line voltage configuration Plug type Line voltage EURO 220 - 240V Australian 240V 10A 200 - 240V UK 220 - 240V Use a 5A fuse which is approved by ASTA or BSI to BSI362. Always replace the fuse cover after changing the fuse. Switzerland 200 - 240V 240V 6A North American 200 - 240V 240V 15A IMPORTANT PRECAUTIONS Moisture Condensation Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the lens and the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature. Place and Manner of Installation • Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the projector. • Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening their lives, and darkening the screen. • Do not use this product in the upright position or tilt it up or down by more than 20° from level. Doing so may cause a failure or shorten the life of the product. • Using this instrument near a TV or radio may cause interference to the images or audio sound. If this happens, move it away from the TV or radio. • In a high altitude location where air is thin, cooling efficiency is reduced so use the projector with [Fan mode] set to [High]. p.58 • Only plug the power cord into outlets rated for use with the power cord's specified voltage range. Do not overload extension cords or table taps as this can result in fire or electric shock. • Route the power cable or the connecting cable away from where people could trip over it. The projector may fall down, which could result in severe injury. • Be sure the power cord is easily reached for unplugging in case of emergency. Do not place any obstacles near a wall outlet in which the cord is plugged.  Before Using