Toshiba TLP-S10 User Manual - Page 9

Names of each part on the control panel and remote control Control panel Remote Control CLASS 1 LED PRODUCT Remote control transmitter (7) (8) (9) (10) FAN TEMP LAMP ON (2) INPUT ON / STANDBY ZOOM + (1) VOL. - MENU (6) VOL. + (5) KEYSTONE AUTO SET (3) ZOOM. - (4) (15) (3) (11) (13) (14) CALL KEYSTONE ON/ STANDBY AUTOSET MUTE FREEZE RESIZE CANCEL INPUT ZOOM+ VOL.- MENU VOL.+ ZOOM- (1) (4) (12) (2) (5) (6) Name (1) ON/STANDBY button (2) INPUT button (3) KEYSTONE button (4) AUTO SET button (5) MENU button (6) Selection buttons (7) FAN indicator (8) TEMP indicator (9) LAMP indicator (10) ON indicator (11) MUTE button (12) FREEZE button (13) RESIZE buttons (14) CANCEL button (15) CALL button : Main Function : Turns the power on/off (standby). p.20 : Selects input. p.22 : Adjusts keystone (trapezoidal distortion). p.25 : Sets up image and mode. p.24 : Displays menus and makes selections. p.29 : Menu selections and adjustments, etc. p.29 : Displays cooling fan mode. p.23 p.35 : Lights when internal temperature too high. p.35 : Displays lamp mode. p.21 : Displays whether power is on or off. p.20 : Cuts off the picture and sound temporarily. p.26 : Pauses image. p.26 : Enlarges picture size. p.27 : Exiting the operation. p.28 : Displays the information on the screen. p.28 Note • For the remainder of this manual, buttons are referred to as follows: Selection buttons ⇒ ; MENU button ⇒ 16 Preparing and using the remote control I Loading dry-cell batteries into the remote control q Remove the battery cover. I Operating the remote control Point the remote control toward the projector's infrared remote sensor, and press a button on the remote control. • Operating the projector from the front w Insert the dry-cell batteries. Be sure to align the plus and minus ends of the batteries properly. Approx. 15° Approx. 5m Two batteries (R03, SIZE AAA) are used. e Replace the battery cover. • Operating the projector from the rear Approx. 15° Approx. 5m Dry-cell batteries • Before using the batteries, be sure to observe the Safety Precautions described in previous pages. • Remove batteries from remote control when not using for extended periods. • If the remote control stops working, or if its range decreases, replace all the batteries with new ones. The remote control • The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting. • Do not drop or bang. • Do not leave in hot or humid locations. • Do not get wet or place on top of wet objects. • Do not take apart. • In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation. 17 Preparations