Toshiba TLP-T400U User Manual - Page 31
How to use the supplied software Continued
View all Toshiba TLP-T400U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
How to use the supplied software (Continued) 5 Configure the projector. [Channel] This item cannot be changed currently. [Encryption] Click on the button to select [Off], [64 bit], or [128 bit]. [Key] This accepts input if Encryption is set to other than Off (input is required). Input a value from the keyboard. [Communication mode] Select Infrastructure by clicking the button. [SSID] This is an ID code for connecting to specific individuals over a wireless LAN. This field accepts input when set to Infrastructure Transmission Mode. Set the SSID to the same value as the access point. In factory shipment, this is set to DPJ. [Projector name] It is recommended this is set to prevent wrong transmission. p.34 [DHCP] Specify by clicking the button. If this is set to Used, the IP Address, Subnet Mask, and Gateway below are set automatically. Consult with a network administrator for the settings below, if DHCP is not used. [IP Address] An IP (Internet Protocol) is a data communication protocol. The delivery destination is an IP address. [Subnet Mask] This value is to set a limit on the range of IP addresses, and set up a number of subnetworks. [Gateway] This is a relay point for connecting different types of network. 6 Press the Settings button. Communication begins, and the computer configures the projector. When setup is finished, a message appears in the window telling you than setup is complete. From the File menu, select Save As..., and save the settings file on the computer. 60 I How to use the JPEG Conversion Tool The JPEG Conversion Tool converts JPEG files not supported by the projector, image files in other formats, Microsoft® PowerPoint® files, and the like into JPEG files supported by the projector. The JPEG files converted with this tool can be displayed by sending them using the wireless LAN PC card p.37 , or saving them on a memory PC card p.41 . G Launching the JPEG Conversion Tool The window shown in the figure to the right appears on the computer screen. Drag the Image Quality Settings slider to the left or right to set the image quality of the file after conversion. Lower values create smaller files, but lower the image quality. (It is not possible to restore the quality of an image after it has been lowered.) G Converting an image file This converts JPEG files using compression formats not supported by the projector, Windows® metafiles (wmf), and bitmapped files (bmp) into JPEG files. (1) In the Conversion Method field, select Converting image file. (Status on launch) (2) In the File settings field, click on the Browse button for Original Image File Name. The Open dialog box appears. (3) In the Open dialog box: (a) Specify the location of the file to be converted; and (b) In the Files of Type field, click on the button to select the file format. A list of files of that format appear in the Open dialog box. (1) (2) (5) (7)-(a) (4) In the Open dialog box, select the file to convert, then click on the Open button. (3)-(a) (5) In the JPEG Conversion Tool window, in the File settings field, select Browse for File name after conversion. The Save As dialog box appears. (4) (3)-(b) (6) In the Save As dialog box: (a) Specify the location in which to save the converted file; (b) Enter a file name of up to 8 characters in the File Name field; and (c) Press the Save button. (6)-(a) (6)-(b) (6)-(c) (7) (a) In the JPEG Conversion Tool, click on the Conversion button. (b) A confirmation dialog box opens. Click Yes. The computer converts the file. When it finishes a message appears informing you that a JPEG file has been created. (7)-(b) 61 Others