Toshiba TLP-T720U Owners Manual - Page 17

Using handy features (Continued) I Displaying Information [Status display] This displays information about the input signal, lamp use time, etc. Press the button twice. When the button is pressed once, the Setting display menu appears. Pressing it again displays information p.53 . The table below shows what kind of information is displayed. Press the button again to dismiss the display. "Yes": displayed, "No": not displayed Item Description Computer Y/PB/PR Input Input source name Yes Yes RGB signal mode RGB input mode [Note 1] Yes No H-resolution Horizontal resolution (in bits) Yes No V-resolution Vertical resolution (in bits) Yes No H-frequency Horizontal sync frequency Yes No V-frequency Vertical sync frequency [Note 2] Yes No Sync Sync signal polarity [Note 3] Yes No Signal format Y/PB/PR signal format No Yes Video mode Color method of video signal No No Card type PC card type No No Shutter speed Shutter speed of document imaging camera No No Lamp time Time of lamp use [Note 4] Yes Yes Version Firmware version [Note 5] Yes Yes MAC address See page 60 p.60 No No SSID See page 34,61 p.34 , p.61 No No DHCP See page 61 p.61 No No IP address See page 61 p.61 No No Subnet mask See page 61 p.61 No No Gateway See page 61 p.61 No No Video S-video Yes No No No No No No No Yes No PC Card Yes No No No No No No No No Yes Camera Yes No No No No No No No No No No No Yes Yes Yes Yes Yes Yes Yes No Yes [Note 6] No No Yes [Note 6] No No Yes [Note 6] No No Yes [Note 6] No No Yes [Note 6] No No Yes [Note 6] No Notes 1: The mode of supported RGB signals p.69 is shown. 2: Same as the refresh rate of the computer signal. 3: Sync signal polarity shown as P (positive) or N (negative) for [H/V]. 4: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the time displayed approaches 1,500 hours, consult with a store about getting a TLPLW2 replacement lamp (sold separately) prepared. 5: [Version] shows the version of the projector's internal control program. This version is referred to for customer service, etc. 6: Displayed when wireless LAN PC card is being used. Notes • The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again. • Conducting another operation while information is being displayed dismisses the display. 32 Using the wireless LAN PC card Please read this chapter if the model you purchased includes a PC card slot. I Functions The following functions are available via wireless communications, when the wireless LAN PC card and dedicated Wireless Utility software p.24 included with this projector are used. Note: A wireless LAN PC card except the supplied one (or recommended by Toshiba) does not work with this product. Please ask your dealer about the available wireless LAN PC card. 1) Displaying a computer's screen via the projector The computer's desktop screen can be sent, as well as the screens of a variety of software applications, to the projector for display. 2) Displaying an image saved on a computer via the projector JPEG files can be sent to the projector for display. 3) Sending images taken with the projector's document camera to a computer This function is for models equipped with document camera. See "Sending the camera's images to a computer" p.49 for details. 4) Operating the projector by means of a computer Some of the same functions available from the remote control can be performed. I Communication mode This projector supports both Ad-hoc and Infrastructure Communication modes. FAN AUTSOET TEMP LAMP VOL.- ON KAEUYSTTOONE VOL.+ MENU INPUT ON/STANDBY Ad-Hoc Communication Mode This is transmission mode to communicate between wireless LAN equipment. Wireless communication can be performed via the simple configurations. This function can only be used if the projector is in range of the computer's wireless signals. For security reason, confirm the specifications of your computer for the distance that the radio wave can reach. The coverage of this projector may vary, depending on the computer and the surrounding environment. When tested with a PC manufactured by Toshiba with built-in wireless LAN system, the coverage is approximately 60 m. This figure is not guaranteed and should be considered as merely a guideline. Infrastructure Communication Mode A mixed wireless and wired LAN can be created To LAN, via access points. Connecting to the rest of the Internet, etc. world via a wired LAN or the Internet generally requires a high level of security. Hub FAN AUTSOET TEMP LAMP VOL.- ON KAEUYSTTOONE VOL.+ MENU INPUT ON/STANDBY Access point Use the appropriate transmission mode for your network environment. The instructions in this owner's manual assume that you will be using a simple ad-hoc communication mode setup. 33 Operations