Toshiba TLP-T720U Owners Manual - Page 27
Using the menus, Operating a computer using the remote control
View all Toshiba TLP-T720U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Operating a computer using the remote control A computer can be operated using the projector's remote control. This function is available on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP OS, that is equipped with a USB port which can support USB1.1 (The mouse remote control receiver is also supported on OS 9 or OS X for the Macintosh). However, please note that Toshiba does not guarantee the operation of all computers. 1 Connecting a computer Connect the projector to a computer using the supplied USB cable. See Fig. (1) below. For models equipped with PC card slot, connect the supplied Mouse remote control receiver to the computer. See Fig. (2) below. (1) (2) To USB port To USB port USB MONITOR CONTROL 1 COMPUTER 2 ( Y,PB/PR ) Mouse remote control receiver 2 Operating a computer The mouse remote control function is available when the remote control is set to [PC Mode]. (See "Switching operation modes" p.20 .) Point the remote control at the infrared remote sensor (in models using Mouse remote control receivers, point it at the Mouse remote control receiver), and operate the remote control's buttons. G Moving the mouse pointer Move the pointer control button in the direction that you wish the mouse pointer to move, then press. G To left click Press the L-CLICK button. G To right click Press the R-CLICK button. G To drag and drop Move the pointer control button in a (L-)clicked state, then when the pointer is over the desired location, release the button. G Using the computer's up and down arrow key functions Press the and buttons to switch PowerPoint® slides. Remote Control Front Remote Control Rear Pointer control R-CLICK VOL.- VOL.+ PJ MODE MENU / ENTER R-CLICK INPUT LASER L-CLICK 52 Using the menus You can call up on-screen menus, and conduct a number of adjustments and settings, using the operation buttons p.16 on the control panel (main unit side) and remote control. I How to use the menus The menu shown below is only for operation instructions and might be different from the actual display. 1. Start Display the Setting display menu 2. Select a Category Select a category by using . There are following four categorys. Image adjustment menu p.54 Default setting menu p.54 Display setting menu p.55 PC card setting menu p.55 Displays the current adjustments of selected category. Item shown with gray cannot be adjusted for the current input source. Press to open the menu 3. Adjustments & Settings of the selected category. Item Adjustment/Setting Value 5. To Finish Finish via the Status display menu. These marks signify the items can be adjusted/set by using . These marks signify an item can be switched by using . This mark signfy that there are options. Press to display a list of options. The figure shows a typical example. As the display may differ depending on the item, use the following pages as a reference. These marks signify the items can be selected from the list by using . After an item selected, apply it by pressing . 4. Back To Status display p.32 6. End The menu disappears Note • Menu adjustments and settings (except Lamp power p.54 ) are saved when the power is turned off via the ON/STANDBY button. If the power cord is unplugged before this, or the power goes out, then the data will not be saved. 53 Operations