Tripp Lite BCPRO600 Owner's Manual for BC Pro UPS 932621 - Page 4

200609130 93-2621 BCPro OM.qxd 9/20/2006 12:17 PM Page 4 Quick Installation optional These connections are optional. The UPS will function properly without these connections. 1 Phone Line/Network Line Surge Suppression NORM DELAY The UPS has jacks which protect against surges over a phone or network data line. Using telephone cords as appropriate, connect the wall jack to the UPS jack marked "IN." Connect equipment to the UPS jack marked "OUT." Make sure the equipment connected to the UPS jacks is also protected against surges 1 on the AC line. 2 USB Communications NORM DELAY Use any USB cable to connect the computer's USB port to the USB port of the UPS. Download the PowerAlert UPS monitoring software program appropriate for the computer's operating system from www.tripplite.com/software/ and install it. 2 Basic Operation Buttons ON/OFF Button: Switch the Operating Mode: While the UPS is plugged into a live AC outlet, press the ON/OFF button and hold it until the UPS beeps (about 2 seconds) to toggle between ON and OFF. • ON Mode: ENABLES battery backup. UPS Conditions: The UPS charges the battery and supplies power to the outlets while receiving utility line power. The " " indicator light will illuminate. If utility power fails, the UPS provides power from battery. Cold-Start: Cold start the UPS to use it as a stand-alone power source when utility power is not present (if the UPS battery is charged). To cold start the UPS, press and hold the ON/OFF button until the UPS beeps (about 2 seconds), then release it. The " " indicator will illuminate and AC power inverted from stored battery power will be provided to the outlets. 4