Troy-Bilt TB210 Operation Manual - Page 13
Controls and Features - mower parts
View all Troy-Bilt TB210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Controls and Features Drive Control Electric Start Ignition Switch Recoil Starter Grass Catcher Blade Control Cutting Height Adjustment Lever Side Discharge Chute Mulch Plug 4 Deck Wash Cutting Height Adjustment Lever Figure 4-1 Blade Control Deck Wash (If Equipped) The blade control is attached to the upper handle of the mower. Depress and squeeze it against the upper handle to operate the unit. Release it to stop engine and blade. WARNING: This blade control is a safety device. Never attempt to bypass its operations. Drive Control The drive control is located on the underside of the upper handle and is used to engage the drive. Squeeze it against the upper handle to engage the drive; release it to slow down or stop mower from propelling. Cutting Height Adjustment Lever One adjustment lever is located on the right rear wheel and one is located on the right front wheel. Both levers have to be at the same relative position to ensure a uniform cut. To adjust the cutting height, refer to the "Assembly & Set-Up" Section. Your mower's deck may be equipped with a water port on its surface as part of its deck wash system. Use the deck wash to rinse grass clippings from the deck's underside. Side Discharge Chute Your mower is shipped as a mulcher. To discharge the grass clippings to the side instead, follow the instructions in the "Assembly & Set-Up" section to attach the side discharge chute. WARNING: Keep hands and feet away from the chute area on cutting deck. Refer to warning label on the unit. Recoil Starter The recoil starter is attached to the right upper handle. Stand behind the unit and pull the recoil starter rope to start the unit. Electric Start Ignition Switch (If Equipped) The electric start ignition switch is located on the right side of the upper handle. It is used only for the electric starter. 13