URC KP-4000C Owners Manual - Page 8

KP-4000 NETWORK KEYPAD Installation Notes MAC Address Labels/Reset Button MAC Address Label Reset Button The KP-4000 has a magnetic cover, simply pull it away from the keypad's main body to remove. Reset Button: Press this button to reset the keypad. MAC address Labels: Tear off the 2nd label and stick it to your Job Documentation indicating which room the KP-4000 is installed. You'll need the MAC address when you program the KP-4000. Connections LAN PoE RJ-45 (Connects KP-4000 to Network) IR OUT/RFTX-1 (only required if URC RF Lighting, RF Base or a wired emitter is needed) 12V Power (not required in a PoE installation) In most installations, you will power the KP-4000 via a single CAT 5 cable connected to the network. The KP-4000 is PoE, so you can power it from either a PoE power injector or any PoE switch. LAN PoE RJ-45: Plug an Ethernet RJ45 cable into a PoE switch or PoE injector (available via the URC Toolbox) to power the KP-4000 or directly connect to a LAN Router if a Power Adapter has been connected. Page 5