URC LT-3201-GR Owners Manual - Page 8

LT-3200 Switch Switch Parameters Parameter Change at the # Switch? About Description Range 1 Yes Power On State Default power state the switch will revert to after power loss. (0 - Return to State | 1 - On | 2 - Off) 0,1,2 2 Yes Invert Switch Inverts the switch. (0 - Disabled | 1 - Enabled) 0,1 3 No Auto Off Timer Automatically turns the switch off after X amount of seconds. 0-32767s Sets when the switch should send commands to an associated device. (01 - Local | 02 - 3-way | 03 - 3-way & Local | 04 - Z-Wave Hub | 05 - Z-Wave 4 No Association Behavior Hub & Local | 06 - Z-Wave Hub & 3-way | 07 - Z-Wave Hub & Local & 3Way | 08 - Timer | 09 - Timer & Local | 10 - Timer & 3-Way | 11 - Timer & 01-15 3-Way & Local | 12 - Timer & Z-Wave Hub | 13 - Timer & Z-Wave Hub & Local | 14 - Timer & Z-Wave Hub & 3 -Way | 15 - All) 5 Yes LED Indicator Color Sets the default color of the LED Bar. 0-255 6 Yes LED Indicator Intensity Sets the intensity of the LED Bar. (0 - Off | 1 - Low | 5 - Med | 10 - High) 0-10 7 Yes LED Indicator Intensity of the LED Bar when the switch is off. (0 - Off | 1 - Low | 5 - Med Intensity (When Off) | 10 - High) 0-10 8 No LED Indicator Effect Allows the LED Bar to perform different effects as notifications. Use URC Tool 10 No Active Power Sends a report when power levels raise or drop below the assigned value. 0, Reports (0 - Disabled | 10 - 10% of prev report | 100 - 100% of prev report) 1-100% 11 No Periodic Power & Energy Reports Period of time before a report can be sent after a report was already generated. 0-32767s 12 No Energy Reports Sends a report when energy levels raise or drop below the assigned 0, value. (0 - Disabled | 10 - 10% of prev report | 100 - 100% of prev report) 1-100% 13 No Load Type Adjustment Can be used for dumb switch setups. (0 - Detect Type | 1 - Manually Set Type) 0,1 51 No Instant On There is a delay that allows for multi-tap scene control. (0 - No Delay | 1 - Delay) 0,1 Default 0 0 0 15 160 3 1 0 10 3600 10 0 1 Size (Bytes) 1 1 1 1 2 1 1 4 1 2 1 2 1 Config Button Command Features About Clear Notifications Inclusion / Exclusion Disable Internal Relay Enable Internal Relay Z-Wave Signal Test Parameter Configuration Factory Reset Description Clears the RGB Bar of any notifications. 3x Tap of Config Button (30s timeout) Disables the internal relay. Enables the internal relay. Tests the signal strength of the switch. Change the parameters from the switch. Factory reset the switch. Config Button Press / Hold # Press / Sec LED Effect LED Color Duration Press 2x N/A N/A N/A Press 3x Pulse Blue (Default) See desc Press 8x Fast Blink Red 3x Blink Press 8x Fast Blink Green 3x Blink Hold 5-10s Solid Green N/A Hold 10-15s Solid Yellow N/A Hold 20s Solid Red 3x Blink 8