URC R500 Owners Manual - Page 19

Network Installation

Get URC R500 PDF manuals and user guides View all URC R500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

MX-HomePro MXHP-H500 Hub Owner's Manual Network Installation The MXHP-H500 Hub can be installed using a Wi-Fi wireless Ethernet connection, or a traditional hard-ward ethernet connection. When installing the MXHP-H500 Hub for the first time, your installer must perform one of the two following steps: -Connect the MXHP-H500 Hub to your the wireless access point by using the WPS button on the MXHP-H500 Hub, and your the one on the wireless access point. When successfully connected to the wireless access point, the Wi-Fi LED on the MXHP-H500 will glow either blue, green, yellow or red, based on Wi-Fi signal strength. Setup is now complete. If you wish to set specific network settings, see section below. Or -Connect the MXHP-H500 Hub to the local Ethernet network via a wired Ethernet connection. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
19
MX-HomePro MXHP-H500 Hub Owner’s Manual
Network Installation
The MXHP-H500 Hub can be installed using a Wi-Fi
wireless Ethernet connection, or a traditional hard-ward
ethernet connection.
When installing the MXHP-H500 Hub for the first time,
your installer must perform one of the two following
steps:
-Connect the MXHP-H500 Hub to your the wireless access
point by using the WPS button on the MXHP-H500 Hub,
and your the one on the wireless access point. When
successfully connected to the wireless access point, the
Wi-Fi LED on the MXHP-H500
will glow either blue,
green, yellow or red, based on Wi-Fi signal strength. Setup
is now complete. If you wish to set specific network
settings, see section below.
Or
-Connect the MXHP-H500 Hub to the local Ethernet
network via a wired Ethernet connection.