Uniden 420 English Owners Manual - Page 4

INITIAL SETUP INITIAL SETUP INITIAL SETUP 420 DISPLAY IDLE MODE CALLER ID DISPLAY *NOTE: ■ The Record Number will only appear when reviewing Caller ID Records. IN-USE DISPLAY INSTALLATION DESK/WALL MOUNTING BRACKET The 420 desk/wall bracket is factory configured in the DESK position. To convert to wall mounting, slide the bracket as shown. Rotate and replace the bracket in the WALL position. Install two screws into the wall using the template as a guide. Purchase wood screws, round head, brass, size #10, 1/4 inch in length. Thread the telephone line cords through the channel on the bottom of the unit. Desk Mount Wall Mount CONNECTING THE TELEPHONE BACK PANEL CONNECTIONS INSTALLING THE BATTERY The 9 volt battery (not included) is required for the telephone to operate when there is a power failure. Use alkaline battery only. See POWER FAILURE OPERATION on page 36. 1 . Remove the screw securing the battery compartment cover. 2 . Open the battery compartment cover by pressing the tab. 3 . Install the battery as shown. 4 . Replace the battery compartment cover and tighten the screw. SIDE PANEL CONNECTIONS 6 7