Uniden BEARCAT 880 English Owner's Manual - Page 17

Problem Using MEM/SCAN does not access channels in memory Unit does not work as well as previously. Battery power check returned FAILLO or FAILHI. Antenna check returned FAIL. RF power diagnosis check returned FAIL. Suggestion Verify that there are channels saved into memory. Turn the power off then back on. The channels will reset. Make sure your power wires have a good connection. Check your battery charge; it needs to be fully charged. Lower voltage will cause a failure. Check your alternator. Make sure your antenna ground is good. Check for damage to the antenna. Check the SWRs at a CB shop. High SWRs will damage the radio. Make sure your antenna ground is good. Check for damage to your antenna. Check the antenna connection on the back of the radio. Be sure it is tight. If you do not get satisfactory results after performing these checks, call the Uniden Customer Service Center at 1-800-297-1023, 8:00 a.m. to 5:00 p.m. CST, Monday through Friday. Servicing Your Transceiver Technical information, diagrams, and charts are provided on request. It is the user's responsibility to see that this radio is operating at all times in accordance with the FCC Citizens Radio Service regulations. We highly recommend that you consult a qualified radio/telephone technician for servicing and aligning this CB radio product. When ordering parts, be sure to specify the correct model number and serial number of the unit. SpEcifications GENERAL Channel: Frequency Range: Frequency Control: 40 26.965 - 27.405 MHz PLL Synthesizer 17