Uniden D1760-2W English Owner's Manual - Page 18

FCC Part 15 Information, FCC RF Exposure Information

Page 18 highlights

able your alarm equipment. If you have questions about what will disable alarm equipment, contact your telephone company or a qualified installer. Any changes or modifications to this product not expressly approved by the manufacturer or other party responsible for compliance could void your authority to operate this product. NOTICE: According to telephone company reports, AC electrical surges, typically resulting from lightning strikes, are very destructive to telephone equipment connected to AC power sources. To minimize damage from these types of surges, a surge arrestor is recommended. FCC Part 15 Information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone. FCC PART 15.105(b): Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: xxReorient or relocate the receiving antenna. xxIncrease the separation between the equipment and receiver. xxConnect the equipment into an outlet on a circuit different from that to which the receiver is connected. xxConsult the dealer or an experienced radio/TV technician for help. FCC RF Exposure Information This product complies with FCC radiation exposure limits under the following conditions: xxThe base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all persons during normal operation. xxThe base must not be collocated or operated in conjunction with any other antenna or transmitter. xxThe handset is designed for body-worn operation and meets FCC RF exposure guidelines when used with any belt clip, carrying case, or other accessory supplied with this product. (All necessary accessories are included in the package; any additional or optional accessories are not required for compliance with the guidelines.) Third party accessories (unless approved by the manufacturer) should be avoided as these might not comply with FCC RF exposure guidelines. Disable All Functions Except Charging D1760 Base 1. Plug in the AC adapter. 2. Immediately begin to press FIND HS repeatedly on the base. All functions will be disabled after FIND HS is pressed approximately 20 times in 15 seconds. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

18
able your alarm equipment. If you have
questions about what will disable alarm
equipment, contact your telephone
company or a qualified installer.
Any changes or modifications to this
product not expressly approved by the
manufacturer or other party respon-
sible for compliance could void your
authority to operate this product.
NOTICE: According to telephone com-
pany reports, AC electrical surges, typi-
cally resulting from lightning strikes,
are very destructive to telephone
equipment connected to AC power
sources. To minimize damage from
these types of surges, a surge arrestor is
recommended.
FCC Part 15 Information
°is device complies with part 15 of
the FCC rules. Operation is subject to
the following two conditions: (1) °is
device may not cause harmful interfer-
ence, and (2) °is device must accept
any interference received, including
interference that may cause undesired
operation. Privacy of communications
may not be ensured when using this
phone.
FCC PART 15.105(b):
Note: °is
equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to part 15
of the FCC Rules. °ese limits are
designed to provide reasonable protec-
tion against harmful interference in a
residential installation. °is equip-
ment generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
x
Reorient or relocate the receiving
antenna.
x
Increase the separation between the
equipment and receiver.
x
Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
x
Consult the dealer or an experienced
radio/TV technician for help.
FCC RF Exposure Information
°is product complies with FCC radia-
tion exposure limits under the follow-
ing conditions:
x
°e base must be placed to allow a
minimum of 20 cm (8 inches) between
the antenna and all persons during
normal operation.
x
°e base must not be collocated or
operated in conjunction with any other
antenna or transmitter.
x
°e handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory sup-
plied with this product. (All necessary
accessories are included in the package;
any additional or optional accessories
are not required for compliance with
the guidelines.) °ird party accessories
(unless approved by the manufacturer)
should be avoided as these might
not comply with FCC RF exposure
guidelines.
Disable All Functions Except
Charging
D1760 Base
1.
Plug in the AC adapter.
2.
Immediately begin to press
FIND HS
repeatedly on the base. All functions
will be disabled after
FIND HS
is
pressed approximately 20 times in
15 seconds.