Uniden DECT1580-4 English Owners Manual - Page 51

Using the Answering System To operate from a remote location, use any touch-tone telephone, and follow these steps: 1) Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after about ten rings and sounds a series of beeps. ) During the greeting or the beeps (if answering system is off), press 0 and enter your security code/PIN within two seconds. 3) The answering system announces the current time and the number of messages stored in memory.. You hear "To play incoming messages, press zero-two. For help, press one-zero" followed by a beep. 4) Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the first command, you have two seconds to enter each command. If you want to Play incoming messages Repeat this message Go back to the previous message Skip this message Delete this message Press 0 then 2 The answering system plays back messages for four minutes, then waits for another command. To continue playing your messages, press 0 then 2 again. 0 then 1 (after the first four seconds of this message) 0 then 1 during the first four seconds of a message 0 then 3 0 then 4 If you want to Stop the current operation to enter a different command. Turn the answering system off Turn the answering system on Listen to the help prompts Exit the system Press 0 then 5 0 then 9 0 then 6 1 then 0 Hang up. 5) When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode. Enter another command from the chart within fifteen seconds. 6) Hang up to exit the system. The answering system automatically returns to its normal standby setting. 51