Uniden DWX207 English Owners Manual - Page 9

Installing the Belt Clip, compartment. Tighten

Get Uniden DWX207 - Cordless Extension Handset PDF manuals and user guides
UPC - 050633271575
View all Uniden DWX207 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

5) Insert the bottom end of the cover into the grooves on the handset and lay the cover over the battery compartment. Tighten the four screws securely. Notes: • If there is any foreign matter on the rubber seal located on the under side of the battery cover, the handset may not be water tight. • The rubber seal should be replaced every two years, even if it does not look worn. Installing the Belt Clip Insert the tabs on the sides of the belt clip into the holes on either side of the handset. Press the belt clip down until it clicks into place. (Tug on the clip to make sure it's secure.) To remove the belt clip, gently pull the tabs out of the holes, then slide the belt clip off of the handset. 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
8
Insert the bottom end of
the cover into the grooves
on the handset and lay
the cover over the battery
compartment. Tighten the
four screws securely.
Notes: • If there is any foreign
matter on the rubber seal
located on the under side
of the battery cover, the
handset may not be
water tight.
• The rubber seal should
be replaced every two
years, even if it does not
look worn.
5
)
Installing the Belt Clip
Insert the tabs on the sides of the belt clip
into the holes on either side of the handset.
Press the belt clip down until it clicks into
place. (Tug on the clip to make sure it’s
secure.)
To remove the belt clip, gently pull the tabs
out of the holes, then slide the belt clip off
of the handset.