Uniden EZI996 English Owners Manual - Page 10

• Make sure your battery pack is fully charged before choosing the dialing mode. • If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may switch over to tone dialing. (Refer to "Tone Dialing Switchover" on page 19.) C. Choose the Dialing Mode Most phone systems use tone dialing which sends DTMF tones through the phone lines. However, some phone systems (such as those in rural areas) still use pulse dialing. The default setting is tone dialing. Depending on your dialing system, set the mode as follows: Place the switch in the tone position for tone dialing, or the pulse position for pulse dialing. If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is. Otherwise set for pulse dialing. D. Set the Visual Ringer Brightness The visual ringer switch allows you to set the brightness of the visual ringer LED on the base. There are three options to choose from: high, low and off. If you set the switch to off, visual ringer LED never flashes. 10 G E T T I N G S T A R T E D www.uniden.com