Uniden MHS235 English Owner's Manual - Page 14

Normal Mode with Weather Alert Watch If you activate Weather Alert Watch while Monitoring Channel 25 operating in Normal mode, the radio checks the most recently used weather channel every seven seconds. If it detects a weather or other hazard alert, it will switch to that weather channel. (If you are actively transmitting, the radio waits until you finish your transmission before checking the weather channel.) Every 7 seconds, the radio checks wx the last-used weather channel. WX Alert Normal Mode with Triple Watch or Dual Watch Watch on If you activate Triple Watch while operating in Normal mode, the radio checks channels 16 and 9 every few seconds; with Dual Watch turned on, the radio only checks channel 16. The radio will not check channels 16 or 9 while you are actively transmitting; it waits until your transmission is finished and then checks the channels. Scan You can save any channel (except Weather channels) into memory and then use Scan mode to monitor those channels from lowest to highest. If the radio detects a signal on a channel, it stays on that channel as long as the signal is received; when the signal stops, the radio continues scanning. When it detects a signal, the radio stays on the channel until you press the Channel Up button or the signal stops. 08 10 11 12 13 14 Resume scan 15 17 The radio scans about 5 channels in 0.3 seconds. Using the Radio in Scan Mode xx To activate Scan mode, press and hold CLR/SCAN. The radio scans channels in memory. xx You must have at least two channels in memory to start a scan. xx You cannot transmit while in Scan mode. xx To save a channel into memory, select the channel, then press and hold the GPS/ MEM button. The MEM icon displays whenever you tune to that channel. xx To remove a channel from memory, set the radio to that channel, then press and hold the GPS/MEM button. The MEM icon no longer displays. xx When the radio stays on a channel, press Channel Up to leave that channel and resume scanning. xx To end the scan, press and hold the CLR/SCAN button again; the radio remains on the last scanned channel. You can also press WX/SOS to change to Weather mode. Scan Mode with Weather Alert Watch When you activate Weather Alert Watch through the Normal menu while in Scan mode, the radio checks the most recently-used weather channel every seven seconds, then continues scanning the next channel in memory: E-10 Uniden MHS235 Radio Owner's Manual