Uniden PC68LTW English Owners Manual - Page 7
Connecting The Power Cords, Ground Information - accessories
UPC - 050633550052
View all Uniden PC68LTW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
pc68ltw.qxd 2/23/99 3:09 PM Page 5 CONNECTING THE POWER CORDS We recommend connecting the power lead to the Ignition Switch Accessory Terminal. This way, the transceiver is automatically turned off when the ignition switch is turned off. Or, the power cord may be connected to an available terminal on the fuse block, or, to a point in the wiring harness. However, caution must be taken to prevent a short circuit. If in doubt, contact your vehicle dealer for information. GROUND INFORMATION This transceiver may be installed and used in any 12-volt DC negative or positive ground system vehicle. Most newer U.S. and foreign made cars, and small trucks, use a negative ground system. Some older cars, and some new large trucks, use a positive ground system. With a negative ground system, the negative (-) battery terminal is usually connected to the vehicle motor block. If you cannot determine the polarity system of your vehicle, contact your vehicle dealer for information. Negative Ground System If you have a negative ground system, connect the red DC power cord from the transceiver to the positive (+) battery terminal or other convenient point. Then connect the black power cord to the vehicle chassis or negative (-) battery terminal. Positive Ground System If you have a positive ground system, connect the black DC power cord from the transceiver to the negative (-) battery terminal or other convenient point. Then, connect the red power cord to the vehicle chassis or the positive (+) battery terminal. 5