Uniden WIN1200 English Owners Manual - Page 55

Resetting the Voice Mail Waiting Light If the voice message waiting light continues blinking even after you've retrieved your messages, press and hold FIND HS key until the light stops blinking. Changing the Digital Security Code The digital security code is an identification code used to connect the handset and the base. Your unit comes with a preset security code. Resetting this code is not normally necessary. In the rare situation that you suspect another cordless telephone is using the same security code or if you are instructed to change this code by a Call Center Representative, reset the handset to change the code (see Resetting the Handset on page 53). Traveling Out of Range During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection for 30 seconds after the handset goes out of range. If you move the handset back within range of the base within 30 seconds, press TALK/FLASH or SPEAKER to pick up the call again. Common Issues If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve your problem, please call our Customer Hotline (see back cover page). Symptom Suggestion The charge LED won't come on when the handset is placed in the base. • Make sure the AC adapter is plugged into the base and wall outlet. • Make sure the handset is properly seated in the base. • Make sure the charging contacts on the handset are clean. The audio sounds weak. • Move the handset and base away from metal objects or appliances. • Make sure that you are not too far from the base. 54