Via EPIA-EN12000EG User Manual - Page 26
Case Connector, F_PANEL, Power Switch PW_BN, Reset Switch RST_SW, Power LED -PLED, HDD LED HD_LED,
UPC - 825529003567
View all Via EPIA-EN12000EG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 2 Case Connector: F_PANEL The F_PANEL pin header allows you to connect the power switch, reset switch, power LED, sleep LED, HDD LED and the case speaker. Pin Signal 1 +5VDUAL 3 +5VDUAL 5 -PLED 7 +5V 9 NC 11 NC 13 SPEAK 15 Key Pin Signal 2 +5V 4 HD_LED 6 PW_BN 8 GND 10 RST_SW 12 GND 14 +5V 16 -SLEEP_LED F_PANEL 1 2 Power Switch (PW_BN) Connect to a 2-pin power button switch. system power on or off. 15 16 Pressing this button will turn the Reset Switch (RST_SW) The reset switch is used to reboot the system rather than turning the power ON/OFF. Avoid rebooting the system, if the HDD is still working. Connect the reset switch from the system case to this pin. Power LED (-PLED) The LED will light when the system is on. If the system is in S1 (POS - Power On Suspend) or S3 (STR - Suspend To RAM) state, the LED will blink. HDD LED (HD_LED) HDD LED shows the activity of a hard disk drive. Avoid turning the power off when the HDD LED still has a lit. Connect the HDD LED from the system case to this pin. Speaker The speaker from the system case is connected to this pin. 18