Vaddio PowerVIEW HD-22 User Guide - Page 7

PowerVIEW HD-22 and HD-30 FIRST TIME SET-UP WITH THE POWERVIEW HD-22 OR HD-30: The PowerVIEW HD-22 and HD-30 were designed to be very easy to use and operate. There is documentation at the back of this manual for pin-outs of the connectors on the PowerVIEW HD-22 camera. Step 1: Using the HD VIDEO SELECT rotary switch and CAMERA SETTINGS dip switches on the back of the camera, set up the camera's output resolution and functional preferences. There is a label on the bottom of the camera that identifies the choices. Important Dip Switch Note: Setting all dip switches down and power cycling the camera will load the factory default camera settings. For the first time set-up, loading the defaults may be a good idea. Image: PowerVIEW HD-22/30 Rear Panel Connections HD Video Select Switch Camera Settings 10-Pos Dip Switch HD-22 Rear Panel Drawing: Dip Switch and Resolution Label on the Bottom of the HD-22/30 IR 1 1 & 2 UP DIP SWITCH SETTINGS IR OUT OFF 9600 bps 5 OFF HDMI IMAGE 6 COLOR FLIP 9 OFF YCbCr OFF OFF 10 OFF IR 2 IR 3 38400 ON ON ON bps 12345 sRGB ON 6 7 8 9 10 VIDEO RESOLUTION SELECT 0 720p/59.94 8 576p/50 1 1080i/59.94 9 2 1080p/59.94 A 3 B 4 720p/50 C 5 1080i/50 D 6 1080p/50 E 1080p/29.97 7 480p/59.94 F 1080p/25  Set the desired and available HD output resolution for the camera with the Rotary Switch.  Set the IR frequency of the camera if it is to respond to the IR remote control.  If using the IR forwarding feature, set the IR OUT switch to ON (SW3).  Set the Baud Rate dip switch (SW4) to 9600bps for most applications. Default for Vaddio EZCamera Cabling Systems is 9600bps.  To set the HDMI or DVI color space, use dip switch 7 (SW7).  If inverting the camera, turn the IMAGE FLIP ON (SW8). Dip Switch Settings: IR 1 & 2: The IR remote has the capability of operating up to three different PTZ cameras from one remote. Use the selector buttons at the top of the IR remote to select the frequency. IR Out 3: The IR output is sent out on the RS-232 RJ-45 jack on the back of the camera. Turning on the IR output will allow IR signals to be transmitted over the Cat-5 cable to the head end. When using RS-232 control or Vaddio CCU controllers (also via RS-232), turn the IR OUT to OFF (up). Baud Rate 4: The options for baud rate are either 9600 bps or 38,400 bps. HDMI Color or sRGB Color space 7: Default is YCbCr. Use sRGB color space with older DVI-D 1.0 monitors only. The YCbCr color space is best for HDMI digital video. Image Flip 8: To invert the HD-20, turn the IMAGE FLIP ON (switch down). Switches 9 and 10: Leave up - or in the OFF position. PowerVIEW HD-22 and HD-30 HD PTZ Cameras Document Number 342-0626 Rev D Page 7 of 16