Vaddio RoboSHOT 12 RoboSHOT 12 and 30 QDVI System Manual - Page 26

General Specifications - hd sdi

Get Vaddio RoboSHOT 12 PDF manuals and user guides View all Vaddio RoboSHOT 12 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

RoboSHOT HD Cameras GENERAL SPECIFICATIONS Function Part Numbers Image Device Video Resolution/Frequencies Vaddio Special Features Video Aspect Ratio Effective Pixels RoboSHOT 12 Lens and Horizontal FOV RoboSHOT 30 Lens and Horizontal FOV Minimum illumination RoboSHOT 12 Minimum illumination RoboSHOT 30 Minimum working distance RoboSHOT 12 Minimum working distance RoboSHOT 30 S/N ratio Sync system White balance Gain Back-light compensation Focusing system Noise Reduction Aperture/Detail Control Interface(s) Pan & Tilt Angle/Speed Rear Panel Connectors Rear Panel Controls Power Supply Compatible Joystick and Video Control Consoles Operating/Storage Temperature/Humidity Mass Dimensions Quick-Connect DVI/HDMI SR Quick-Connect System Connectors Cat-5 Cable Distance Power Supply Dimensions / Weight Accessory Options Description RoboSHOT 12 QDVI System, 999-9906-000 (North America), 999-9906-001 (Int'l) RoboSHOT 30 QDVI System, 999-9916-000 (North America), 999-9916-001 (Int'l) 1/2.8-Type Exmor CMOS Sensor 1080p60/59.94/50/30/25, 1080i/60/59.94i/50, 720p/60/59.94/50/30/25  Tri-Synchronous Motion: Concurrent PTZ motor movement and simultaneous PTZ arrival at a stored preset  Advanced ISP: Vivid and accurate color reproduction with extremely fast, razor sharp automatic focus and iris routines 16:9 Aspect Ratio for all resolutions 2.14 Million Effective pixels 2.38 Million Total Pixels 12X Optical Zoom, Super Wide Mode: 73.0° (wide) to 6.6° (tele),f=3.91mm to 47.0mm, F1.8 to F3.4 10X Optical Zoom, Normal Mode: 67.3° (wide) to 7.6° (tele), f=3.8mm to 38.0mm, F1.8 to F3.4 NOTE: Default is Normal Mode 30X Optical Zoom 65° (wide end) to 2.3° (tele end), F1.6 to F4.7 1.0 lx (F1.8, 50IRE), recommended illumination >100 lux and 100 lux and

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
RoboSHOT HD Cameras
RoboSHOT HD Cameras - Document Number 342-0795 Rev A
Page 26 of 44
G
ENERAL
S
PECIFICATIONS
Function
Description
Part Numbers
RoboSHOT 12 QDVI System, 999-9906-000 (North America), 999-9906-001 (Int’l)
RoboSHOT 30 QDVI System, 999-9916-000 (North America), 999-9916-001 (Int’l)
Image Device
1/2.8-Type Exmor CMOS Sensor
Video Resolution/Frequencies
1080p60/59.94/50/30/25, 1080i/60/59.94i/50, 720p/60/59.94/50/30/25
Vaddio Special Features
Tri-Synchronous Motion:
Concurrent PTZ motor movement and simultaneous PTZ arrival at a stored
preset
Advanced ISP:
Vivid and accurate color reproduction with extremely fast, razor sharp automatic focus
and iris routines
Video Aspect Ratio
16:9 Aspect Ratio for all resolutions
Effective Pixels
2.14 Million Effective pixels
2.38 Million Total Pixels
RoboSHOT 12
Lens and Horizontal FOV
12X Optical Zoom, Super Wide Mode:
73.0° (wide) to 6.6° (tele),f=3.91mm to 47.0mm,
F1.8 to F3.4
10X Optical Zoom, Normal Mode:
67.3° (wide) to 7.6° (tele),
f=3.8mm to 38.0mm,
F1.8 to F3.4
NOTE:
Default is Normal Mode
RoboSHOT 30
Lens and Horizontal FOV
30X Optical Zoom
65° (wide end) to 2.3° (tele end), F1.6 to F4.7
Minimum illumination
RoboSHOT 12
1.0 lx (F1.8, 50IRE), recommended illumination >100 lux and <100,000 lux
Minimum illumination
RoboSHOT 30
1.4 lx (F1.6, 50IRE), recommended illumination >100 lux and <100,000 lux
Minimum working distance
RoboSHOT 12
10mm (wide), 800mm (tele)
Minimum working distance
RoboSHOT 30
10mm (wide), 1.2m (tele)
S/N ratio
More than 50 dB
Sync system
Internal
White balance
Auto, ATW, Indoor, Outdoor, One-push, Manual (accessible through external control)
Gain
Auto / Manual (0 to 28 steps - accessible through external control)
Back-light compensation
On/Off (IR Remote)
Focusing system
Auto Focus / Manual Focus Mode / One Push Trigger Mode / Infinity Mode / Near Limit Mode
Noise Reduction
On/Off, 6 Steps, Off
through 5 (accessible through external control)
Aperture/Detail
16 Steps (accessible through external control)
Control Interface(s)
RS-232 API:
Modified VISCA Emulation (TTL signal level), Baud rate: 9600 bps and 38,400 bps, 1-Stop
bit. Default to 9.6 Kb/s for Cat-5e Distance
Telnet Serial Command API
Internal Web page for Network Set-up, firmware updates and network management
Vaddio IR Remote Commander
Pan & Tilt Angle/Speed
Pan/Tilt
Angles: ±160°, Tilt: +90°, -30°,
Pan/Tilt Speeds:
Both Axes 0.35°/sec to 120°/sec
Rear Panel Connectors
Network:
RJ-45 with Green & Yellow LED to show connection and usage
RS-232:
RJ-45, Carries bidirectional control to and from the camera
EZ Power Video:
RJ-45 Shielded,
carries power and differential video signals for the Quick-Connect
Cat-5 systems
Rear Panel Controls
16-Position Rotary Switch for Resolution selection
8-Position Dip Switch for IR Frequency, Image Flip, wide mode and Reset to Default Settings
Power Supply
Powered by Quick-Connect interfaces
Compatible Joystick and Video Control
Consoles
ProductionVIEW Precision Camera Controller
ProductionVIEW HD
ProductionVIEW HD MV with Integrated Multi-viewer,
ProductionVIEW HD-SDI MV with Integrated Multi-viewer
AV Bridge MATRIX PRO
Operating/Storage Temperature/Humidity
0°C (32°F) to 40°C (104°F), 20% to 80%
Mass
4.85 lbs.(2.199923 kg - Roughly 900 peanut M&Ms)
Dimensions
Small (3 dimensions not counting space/time)
6.942” (176.3mm) H x 7.056” (179.2 mm) W x 6.757” (171.6mm) D,
Quick-Connect DVI/HDMI SR
Quick-Connect System
Quick-Connect DVI/HDMI (two Cat-5e) for distances up to 100’ (30.84m)
HDMI or DVI-D and Analog Component YPbPr output with IR forwarding
Connectors
Power Connector:
5.5mm OD, 2.5mm ID coaxial connector
RJ-45:
Four (4) Control IN, Control OUT, Daisy Chain OUT, EZCamera Power Video Port
Video Output:
DE-15 connector for HD Analog Component (Y,PB,PR) video only (No SD Support)
IR Output:
Transmits modulated or non-modulated IR signals received from the HD-19 IR receiver
Video Outputs:
DVI-D (Female - Single Link) or HDMI with adapter cable (using the Recessed Color
Space Conversion Switch) , DE-15F (High Density D-Sub 15-Pin F) for HD YPbPr
Cat-5 Cable Distance
Up to 100’ (30.5m)
Power Supply
24 VDC, 2.0 Amp Switching Power Supply
Dimensions / Weight
1.6” (40.64mm ) H x 8” (203.2mm) W x 6.751” (171.45mm) D, ½-Rack Size / 1.21 lbs. (0.548846804 kg)
Accessory Options
1-RU Rack Mount Panel for two (2) units (side by side):
P/N:
998-6000-003
1m (3.3’) DVI-D Male to HDMI Male P/N:
440-5643-001
3m (10’) DVI-D Male to HDMI Male P/N:
440-5643-003