ViewSonic G75F User Manual - Page 5

Quick Installation E N G L I S H 1 Connect video cable Make sure both the monitor and computer are powered OFF. Connect the video cable to the computer. Macintosh users: Models older than G3 require a Macintosh adapter. Attach the adapter to the computer and plug the video cable into the adapter. To order a ViewSonic® Macintosh adapter, contact ViewSonic. See Customer Support in this user guide. NOTE: If your computer does not have a CD-ROM drive, see Customer Support in this user guide. (2) Wait for the CD-ROM to auto-start. NOTE: If the CD-ROM does not auto-start: double-click on the CD-ROM icon in the Windows Explorer, then double-click on install.exe (3) Follow the on-screen instructions. 2 Connect power cord Connect the power cord from the monitor to a properly grounded AC outlet. 5 Windows users: Set the Timing Mode (resolution and refresh rate) Example: 1024 X 768 @ 75Hz. For instructions on changing the resolution and refresh rate, see the user guide for your computer's graphics card. Installation is complete. Enjoy your new G75f monitor! To be best prepared for any future customer service needs: Write the serial number (see back of the monitor) in "For your Records" on page 2 of this guide. Register your product on the Internet at: www.viewsonic.com 3 Power-ON monitor and computer Power-ON the monitor, then power-ON the computer. This sequence (monitor before computer) is very important. NOTE: At this point Windows 98 users may receive a message asking them to install the G75f INF file. 4 Install display optimization files (INF and ICM files) (1) Insert the ViewSonic Wizard CD-ROM into your computer's CD-ROM drive. Power Cords Video Cable 4 ViewSonic G75f