ViewSonic N2630w User Manual - Page 17

ENGLISH TV Controls Front View of LCD Set TV Inputs(Side) 1. LED indicator lamp 3 2. Remote Sensor 4 3. VOLUME+/VOLUME 5 4. CHANNEL+/CHANNEL 6 5. MENU 7 6. Source 7. Power 21 To turn the TV power ON Put the TV where it can be easily viewed, connect the power plug of AC voltage at the back of the TV set, the LED indicator lamp turns red, then press the Power key. When the LED indicator lamp turns to blue, the TV set power is on. It takes a few seconds before the picture appears. To turn the TV power OFF Press the Power key to make the TV go into the Standby Mode, disconnect the power plug from the wall outlet. NOTE The TV will automatically enter into the standby mode, if the TV has not a signal input and no function is performed for 5 minutes except that the input source of the TV is HDTV. If you are not going to use this TV set for a long time, turn off the set and disconnect the power plug from the wall outlet. When the user presses MENU or Source key, it enters a MENU or source MENU. The user can press CHANNEL+/CHANNEL- to move the cursor up/down and press VOLUME+/VOLUME- selects a parameter to increase/ decrease. Pressing Source to confirm which is the same as "Enter"on the remote. ViewSonic 15 N2630w/N3230w/N3730w