ViewSonic PJ560D PJ260D User Guide - Page 30

Troubleshooting Refer to the symptoms and measures listed below before sending the projector forrepairs. If the problem persists, contact your local reseller or service center. Please refer to "Indicator Messages" as well. Start-up problems If no lights turn on: „ Be sure that the power cord is securely connected to the projector and the other end is plugged into an outlet with power. „ Press the power button again. „ Unplug the power cord and wait for a short while, then plug it in and press the power button again. Image problems If the searching source is displayed: „ Press the SOURCE button on the control panel or the Source button on the remote control one or more times to select another active input source. „ Be sure the external source is turned on and connected. „ For a computer connection, ensure your notebook computer's external video port is turned on. Refer to the computer manual. If the image is out of focus: „ Be sure the lens cover is open. „ While displaying the on-screen menu, adjust the focus ring. (The image size should not change; if it does, you are adjusting the zoom, not the focus.) „ Check the projection lens to see if it needs cleaning. If the image is flickering or unstable for a computer connection: „ Press the RESYNC button on the control panel or the Resync button on the remote control. „ Press the MENU button, go to Computer Image and adjust Frequency or Tracking. Remote control problems If the remote control does not operate: „ Be sure nothing is blocking the remote control receiver on the front or back of the projector. Use the remote control within the effective range. „ Aim the remote control at the screen or at the front or back of the projector. „ Move the remote control so it is more directly in front of or behind the projector and not as far to the side. ViewSonic 24 PJ260D