ViewSonic PS600X - 3700 Lumens XGA Networkable Short Throw Projector User Guid - Page 61
Installing the dust filter, Obtaining the filter hour information, For first time installation
View all ViewSonic PS600X - 3700 Lumens XGA Networkable Short Throw Projector manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
• If your projector is ceiling-mounted or is not easily accessible, pay special attention to your personal safety when replacing the dust filter. Installing the dust filter 1. Be sure to turn off the projector and unplug it from power source. 2. As the arrows shown to the right, fit the filter by aligning and inserting it into the projector slots. 3. Tighten the screw the secures the dust filter. 2 1 3 For first time installation: 4. Open the OSD menu and go to the ADVANCED > Filter Settings menu. 5. Press Enter and the Filter Settings page is displayed. 6. Highlight Filter Mode and press / to select On. The filter timer starts counting. Set Filter Mode to On only when using the projector after the dust filer (optional accessory) is properly attached. Failing to do so will result in a shorter lamp life. Obtaining the filter hour information 1. Open the OSD menu and go to the ADVANCED > Filter Settings menu. 2. Press Enter. The Filter Settings page is displayed. 3. You will see the Filter Hours information on the menu. Cleaning the dust filter 1. Be sure to turn off the projector and unplug it from power source. 2. Loosen the screw the secures the dust filter. 3. Use a small vacuum cleaner or a soft brush to sweep the dust on the filter away. 4. Re-install the dust filter. 2 1 Resetting the filter timer 5. Open the OSD menu and go to the ADVANCED > Filter Settings menu. 6. Press Enter and the Filter Settings page is displayed. 7. Highlight Reset Filter Hours and press Enter. A warning message is displayed asking if you want to reset the filter timer. 8. Highlight Reset and press Enter. The filter time will be reset to '0'. 56