ViewSonic SP2002 User Guide - Page 3

English

Troubleshooting

No sound from any speakers

•

Power is not turned on

- Verify the power adoptor is plugged into the wall outlet.

•

Volume setting is too low

- Verify the Power On switch has been pressed.

- Press the function key to raise the system Master Volume.

- Check volume level on computer sound card or alternate audio source device and set

at

mid

level.

• Audio cable is not connected to audio source

- Connect audio cable from audio source. Make sure thee signal cables are inserted

firmly

into

the correct jacks.

• Audio cable connected to wrong output on audio source

- Make sure that the lime green 3.5 mm stereo jack is connected to the line-out of the

audio

source; make sure it is fully inserted.

Sound is distorted

•

Volume level set too high

- Decrease the speaker system's master volume level.

•

Windows volume control is set too high

- Adjust the Windows volume and balance controls to the center as a starting point, then

use

the speaker controller to adjust the volume.

•

Sound source us distorted

- WAV files are often of poor quality. So distortion and noise are easily noticed with high-

powered speakers. Try a different sound source like a music CD.

Driver

Tweeter: 1” (2.54cm)

Micro Driver Full Range: 2” (5.08cm)

P.M.P.O.

600Watt.

RMS

20Watt

Frequency Range

35

Hz ~ 20 KHz

Amplifier

Internal

Function

Power / Volume

Indicator

Power

Power Supplier

External

Adaptor

AC input Power: 100 ~ 240V

DC output Power: 12V / 1.66A

Connector

Stereo jack / RCA

Dimension

267.7mm (H) x 90mm (W) x 105.3 (D) mm

10.54” (H) x 3.54” (W) x 4.15” (D)

Contents

Connection cables X 2

Adaptor X 1

User Guide X 1

Speaker X 2

Stereo Jack-RCA adaptor x 1 (optional)

THD

<0.4

%@-7dB

Regulations

CCC, BSMI, CE, C-tick, VCCI, ICES003, UL,

FCC-B, CB, NOM, GOST, PCBC, PSB

Specifications

ViewSonic

SP2002

3

ViewSonic SP2002 User Guide - Page 3

Troubleshooting, Specifications - driver

Page 3 highlights