Viking DCCG1304BSS Installation Instructions - Page 9

Leveling/Adjustments/Alignments (cont.) 7 Set the high corner of range so that the top of side trim is 3/8" (0.95 cm) above countertop. Level range to high corner. Anti-tip Device Installation WARNING TIPPING HAZARD To reduce the risk of property damage or personal injury; install anti-tipping device provided in accordance with the installation instructions in this document. Device must be engaged properly to prevent product from tipping over. 1 Measurement (A) Measure from floor to bottom of the anit-tip opening located on the back of range. This will be measurement (A). 2 (2526-.15/c4m" ) 3 M+e1a/s4u"re(m.6e4nctm(A) ) Locate anti-tip bracket on rear wall with the top left corner at measurement (A) plus 1/4" (.64 cm) from the floor and 22-1/4" (56.5 cm) from where the right side of range (facing range) is to be located. 16 Mark and drill holes where bracket will be located. Anti-tip Device Installation (cont.) 4 Attach bracket with mounting hardware provided. Connecting Gas & Electric DANGER GAS LEAK HAZARD To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer's instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS. Note: Refer to electrical and gas requirements section for proper installation information. 1 Connect gas and electrical. Before placing appliance in operation, always check for gas leaks. This must be performed by your dealer, a qualified licensed plumber, or gas service company. 17