Viking DGRT3014BBK Installation Instructions - Page 4

Proximity to Side Cabinet Installation

1. This rangetop may be installed directly adjacent to existing 36” (91.4 cm) high base cabinets.

IMPORTANT:

The top

grate support MUST be 3/8” (.95 cm) above the adjacent base cabinet countertop.

2. The rangetop CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical

surfaces above 36” (91.4 cm) high. There must be a minimum of 6” (15.2 cm) side clearance from the rangetop to

such combustible surfaces above the 36” (91.4 cm) counter height.

3. Within the 6” (15.2 cm) side clearance to combustible vertical surfaces above 36” (91.4 cm) , the maximum wall cabi-

net depth must be 13” (33.0 cm) and wall cabinets within this 6” (15.2 cm) side clearance must be 18” (45.7 cm)

above the 36” (91.4 cm) high countertop.

4. Wall cabinets above the rangetop must be a minimum of 36” (91.4 cm) for the open top burner models and a mini-

mum of 42” (106.7 cm) for the sealed burner models above the rangetop cooking surface for the full width of the

rangetop. This minimum height requirement does not

apply if a rangehood is installed over the cooking surface.

Dim. 24” W. Models

30” W. Models

36” W. Models

42” W. Models

48” W. Models

60” W. Models

A

24” (61.0 cm)

30” (76.2 cm)

36” (91.4 cm)

42 1/8” (107.0 cm)

48” (121.9 cm)

59 5/8” (151.4 cm)

B

A

C

Dim.

B

C

VGRT Open Burners

36” (91.4 cm) min.

7 1/2” (19.1 cm)

VGRT Sealed Burners

42” (106.7 cm) min.

7 5/8” (19.4 cm)

DGRT Sealed Burners

42” (106.7 cm) min.

5 3/4” (14.6 cm)

6

5

GENERAL INFORMATION

1.

WARNING

:

The use of cabinets for storage above the appliance may result in a potential burn hazard. Com-

bustible items may ignite, metallic items may become hot and cause burns. If a cabinet storage is to be provided

the risk can be reduced by installing a rangehood that projects horizontally a minimum of 5” (12.7 cm) beyond the

bottom of the cabinets.

2. All openings in the wall behind the appliance and in the floor under the appliance shall be sealed.

3. Keep appliance area clear and free from combustible materials, gasoline, and other flammable vapors.

4. Do not obstruct the flow of combustion and ventilation air.

5. Disconnect the electrical supply to the appliance before servicing.

6. When removing oven for cleaning and/or service;

A. Shut off gas at main supply

B. Disconnect AC power supply

C. Disconnect gas line to the inlet pipe.

D. Carefully remove the rangetop by pulling out of cabinet cutout.

E. When cleaning and/or service is complete, replace unit in cabinet cutout, reconnect gas line and power sup-

ply, and turn on gas at main supply.

7.

Electrical Requirement

Listed on Specification sheet. Electrical installation should comply with national and local codes.

8.

Gas Manifold Pressure:

Natural gas - 5.0” W.C.P.

LP/Propane - 10.0” W.C.P.

GAS INLET/ELECTRICAL LOCATION

A

B

C

VGRT Models -

Min. 24” (61.0 cm)

3” (7.6 cm)

2 1/4” (5.7 cm)

24”, 30”, 36”, 42”,48” W.

Max. 25 3/4 (65.4 cm)

VGRT Models -

Min. 24” (61.0 cm)

14 3/8” (36.5 cm)

9/16” (1.8 cm)

60” W.

Max. 25 3/4 (65.4 cm)

DGRT Models -

Min. 24 1/2” (62.2 cm)

3” (7.6 cm)

2 1/4” (5.7 cm)

30”, 36” W.

Max. 26 1/8” (66.4 cm)

B

3/4” Min.

(1.9 cm)

A

WARNING

Never use this appliance as a space heater to heat or

warm the room. Doing so may result in carbon monox-

ide poisioning and over heating of the unit.

120 VAC/60 Hz within

48” (121.9 cm) of right

rear of rangetop

Viking DGRT3014BBK Installation Instructions - Page 4

Proximity to Side Cabinet Installation, GENERAL INFORMATION, GAS INLET/ELECTRICAL LOCATION - appliances

Page 4 highlights