Viking DMOR200SS Installation Instructions - Page 4
Preparation of the Oven, Ventilation System - designer
View all Viking DMOR200SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
7 Preparation of the Oven Separate mounting plate from oven by removing two screws. See illustration below. Save these screws for use in section Mounting Oven to Wall, figure /. (B) Horizontal Exhaust: Outside Ventilation 4 5 Mounting Plate figure figure Back of Microwave 1) HORIZONTAL EXHAUST: Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket. figure 6 8 Ventilation System (Preparing Oven for Installation) Hood Fan Unit This Built-in Microwave Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. RECIRCULATING - non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter, which has already been installed in the oven. HORIZONTAL EXHAUST - outside ventilation. Follow installation procedure (B). VERTICAL EXHAUST - outside ventilation. Follow installation procedure (C). 2) HORIZONTAL EXHAUST: Lift Hood Fan Unit carefully and slip wires out of cavity. • CAUTION: Do not pull or stretch hood fan wiring. 7 (A) Rotate 180˚ (B) figure (A) Recirculating: Non-Vented, Ductless Operation • The unit is shipped assembled for recirculating. • The Exhaust Damper Assembly 7 is NOT REQUIRED for recirculating operation. 3) HORIZONTAL EXHAUST: Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 7 (A). Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 7 (B). E4