Viking DMOR206SS Installation Instructions - Page 1
Viking DMOR206SS Manual
View all Viking DMOR206SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Viking Installation Guide IMPORTANT-Please Read and Follow! • Please read all instructions thoroughly before installing the Convection Microwave Hood. Two people are recommended to install this product. • If a new electrical outlet is required, its installation should be completed by a qualified electrician before the Convection Microwave Hood is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2. Mounting Space This Convection Microwave Hood requires a mounting space on a wall as shown in figure 1. It is designed to be used with standard 12-inch wall cabinets. For proper installation and servicing, a 2-inch space is necessary between the top of the range backguard and the bottom of the Convection Microwave Hood. 1 12" 30" 15.5" At least 2" Backguard 36" or more from cooking surface 72" or more from floor Wall Construction This Convection Microwave Hood should be mounted against and supported by a flat vertical wall. The wall must be flat for proper installation. If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a minimum of 2" x 4" wood studding and 3/8" or more thick dry wall or plaster/lath. The mounting surfaces must be capable of supporting a weight of 110 pounds-the oven and contents-AND the weight of all items which would normally be stored in the top cabinet above the unit. The unit should be attached to a minimum of one 2" x 4" wall stud or two 2" x 3" wall studs. To find the location of the studs, one of the following methods may be used: • Use a stud finder, a magnetic device which locates the nails in the stud. • Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate stud location. The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark halfway between the edges. The center of any adjacent studs will normally be 16" or 24" to either side of this mark. Convection Microwave Hood 111 Front Street Greenwood, Mississippi 38930 USA