Viking DMOR206SS Installation Instructions - Page 6

figure figure figure figure figure figure Oven Installation figure figure figure THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON WALL AND TOP CABINET TEMPLATES. Mounting Plate • Separate 4 Toggle Bolts, packed in the INSTALLATION HARDWARE, from the Toggle Nuts. Toggle Bolt Toggle Nut Note: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before insertion. figure figure figure figure figure figure figure figure figure figure figure Mounting Plate MOUNTING PLATE: Use wood screws to attach mounting plate to the stud or studs. Use Toggle Bolts to attach mounting plate through the holes at A, B, C and D UNLESS THOSE HOLES ARE LOCATED ON THE STUD. Insert one Toggle Bolt into A, B, C and D where appropriate (these correspond to holes of the Wall Template) and put the Toggle Nuts onto the Toggle Bolts. • Refer to instructions in Wall Te(mA)plate. Space more than wall thickness MOUNTING PLATE: Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn clockwise to tighten. Mounting Oven to the Wall Utilization of the carton may make installation easier. figure figure figure figure figure figure figure (B) Wall MOUNTING PLATE: Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the holes in the wall with the Toggle Nuts closed. Use Wood Screws to attach the Mounting Plate to studs. (A) (B) Top Side Cutting Line MOUNTING OVEN TO THE WALL: Place carton upside down. E6 figure figure figure figure figure figure figure figure figure