Viking DSCE1304BSS Installation Instructions - Page 11

Anti-tip Device Installation (cont.) 4 1 2 Attach bracket with mounting hardware provided. Final Installation 1 Note: Refer to range electrical requirements section for proper installation information. Connect electrical in shaded area. See the "Electrical Requirements" section for more information. 2 3 Slide range into place. Be sure anti-tip bracket slides into the anit-tip opening. (03.9/58"cm) Check that unit is level side to side and front to back. The side trim must be 3/8" (0.95 cm) above countertop. If unit is not level repeat steps 5-7 of "Leveling/Adjustments/Alignment" section. 20 Door Replacement and Adjustment 1 2 Reattach door to range. 3 2 1 2 3 Open door completely. Reattach hinge trim. 4 Remove pins from hole in hinges. 5 Close door. If the door needs to be adjusted, loosen hinge trim screws (see step 2). Adjust the screws located between the door and kickplate using a 5/32" hex head allen wrench. After adjustment, tighten hinge trim screws. 21