Viking FDWB301R Use and Care Manual - Page 10

Changing Light Tube (middle zone) To change the light tube, first remove the center grille assembly and turn the power ON/OFF switch to the OFF position (see the Before Using Your Wine Cellar section). 1. Remove the lamp wire cover by removing the two screws located on the upper left side of the middle zone. (NOTE: ONLY REMOVE THE TWO SCREWS HOLDING THE WIRE COVER; DO NOT REMOVE SHELF MOUNTING SCREWS). 2. Set the wire cover and screws to the side. 3. Disconnect the lamp by disconnecting one yellow and one white wire from each lamp. 4. Remove the clamp and screw located at the end of the lamp. The lamp is located on the underside of the middle mullion shelf. 5. Carefully unsnap light tube from shelf and snap new light tube into place. 6. Reassemble in reverse order. Home Security System Connection Home Security System Connection The wine cellar may be connected to your home security system to protect your wine while away from home. Contact a qualified technician or your home security system representative and refer to the wine cellar installation instructions. Door Stop Adjustment Your wine cellar is factory set at 110° door stop position. To change to either the 90° or 120° position, remove door stop pin located in the bottom hinge using a 3/16" allen wrench. For 120° swing, move pin to utmost forward stop hole. For 90° swing, move pin to utmost rear stop hole. Operation Operation Screws Wire Cover Light Clamps 18 120˚ stop (closest to unit) 90˚ stop (farthest from unit) 19