Viking RDSCG2305BSS Installation Instructions - Page 10
Door Replacement and Adjustment, Final Installation
![]() |
View all Viking RDSCG2305BSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Final Installation 1 2 Slide range into place. Be sure anti-tip bracket slides into the anti-tip opening. 3 Burner heads and burner caps are packed in the cardboard top pack with the grates. Align burner head on burner base. Place burner cap on burner head. Place grate onto the burner pan. (03.9/58"cm) Check that unit is level side to side and front to back. The side trim must be 3/8" (0.95 cm) above countertop. If unit is not level, repeat Steps 5-7 in "Leveling/Adjustments/Alignment" section. 18 Door Replacement and Adjustment 1 2 Reattach door to range. 2 2 1 2 3 Open door completely. Reattach hinge trim on both sides. 4 2 1 2 3 Remove pins from holes in hinges. 5 Close door. If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32" hex head Allen wrench. After adjustment, tighten hinge trim screws. 19
![](/manual_guide/products/viking-rdscg2305bss-installation-instructions-dcd10fb/10.png)